Wahl 7061 Serie Mode D'emploi page 6

EN
until charging is complete.
3. Replace the foil head and cutter bars every 12 months or if foils are damaged.
Replacement foils can be ordered at https://home.wahl.com.
4. Be sure to clean the shaver, cutter bars and foil after every three or four shaves.
5. Use the pop-up long-hair trimmer to snip stray hairs.
6. Keep using and both your face and beard will adapt to the shaver.
TRAVEL LOCK
The Wahl 7061 Series Shaver comes with an electronic travel lock to avoid accidental
activation while transporting.
Hold power button down for 3 seconds to engage travel lock.
Hold power button down for 3 seconds to disengage travel lock.
When travel lock is active, pressing the power button will cause the LED(s) to flash for 1
second.
CHARGING OPERATION
The shaver cannot be overcharged, so you may charge it as often as desired. However, peri-
odic recharging of the shaver, rather than continuous recharging, will prolong battery life.
60 minutes charge time will provide you with 90 minutes cordless operation.
Charge when shaver seems to lose power or run slower. The
charging LED will light up while charging. LED will turn off when charging is complete.
Unplug the charger before using appliance. Appliance will not operate when plugged in.
MODELS WITH 1 LED
Charge when shaver seems to lose power or run slower. The charging LED will light up
while charging. LED will turn off when charging is complete.
MODELS WITH 2 LEDS
The red LED will flash for one second when turning off the shaver when it is time to
charge (below 10%).
The blue LED will light up while charging. LED will turn off when charging is complete.
MODELS WITH 5 LEDS
The LED meter will show the amount of charge left on the shaver.The fewer lights that are
lit, the lower the charge on the battery is.The red LED will flash for one second when
turning off the shaver when it is time to charge (below 10%).
While charging, the LED meter will show the progression of charging. All LEDs will turn
off when charging is complete.
SHAVING PROCEDURES FOR FAST, CLOSE SHAVES (A)
For maximum speed and efficiency, hold the shaver so that both screens are in contact
with the skin. When shaving the upper lip or neck, hold shaver so that the uppermost
screen is in contact with skin.
Shave both with and against the grain of the beard, and stretch the skin taut in the path
of the shaver. Guide the dual foil heads gently back and forth, primarily against the grain
of the beard. Do not press screen heads hard against face. Heavy scrubbing action with
the shaver could damage the foil and will not result in a closer shave.
Always replace the foil guard to protect the delicate dual foil heads when shaver is off.
SHAVING HEAVY BEARD GROWTH (B)
Begin shaving in a less dense area of the beard. Move the shaver in a circular motion on a
small area of the face (this picks up the hairs that grow in all directions). When you see that
this small area is shaved clean, gradually move into a new area while still using the circular
motion. Continue this motion, one small section at a time, until entire face is shaved.
6