Wahl 7061 Serie Mode D'emploi page 7

EN
If your beard has more than 3 days of growth, use the pop-up Long-Hair Trimmer to cut
the beard down to about a one-day growth before using the shaver foil.
LONG-HAIR TRIMMER OPERATION (C)
Your shaver features a special long-hair trimmer located on the back of the shaver which
telescopes up from the foil head for precise and easy trimming of sideburns, beards or
mustaches, and for removing long hairs from the neck. And, as mentioned earlier, it can
be used to "knock down" heavy beard growth prior to shaving with the foil.
To use, remove Foil Guard and simply push the Long-Hair Trimmer Switch in an upward
motion until trimmer slides (clicks) into position. Push On/Off Switch. Then begin trim-
ming/styling.
CLEANING AND MAINTENANCE (D) SHAVER HEAD CARE
For maximum performance, we recommend you clean your shaver after every few
shaves. Any servicing, other than replacement of foil head and cutter bars, should be
performed by an authorized Wahl Shaver Service Center or Wahl Clipper Corporation
(see Warranty for mailing address information).
To clean, turn shaver "OFF" and remove the foil head by pushing the shaver head
release buttons on the sides of the shaver and lifting the foil head upward.
Lightly tap the open side of the foil head on a hard surface to remove the majority of
loose stubble particles. Be careful not to tap foil.
For easy cleaning, you may rinse your shaver with water. While the foils can be rinsed,
we recommed removing the foil head, and rinsing the cutter bars. This will allow any
hairs still on the cutter bars to be washed away. Leaving the foil head on while rinsing
makes it more difficult for hairs to be washed clean.
TO REMOVE CUTTER BAR (E)
Turn shaver off. Remove the foil head and, holding the shaver in one hand, gently pull up on
cutter bar. Be sure your thumb and first finger are positioned at each end of the cutter bar.
: Handle cutting components with care to avoid personal injury.
WARNING
NOTE: If you do not hold the cutter bar as shown, brushing the blades could result in
damage to the assembly.
When the foil head and cutter bars are removed from the shaver, an alternate cleaning
method is to rinse them under running water. Simply let them air dry.
After cleaning, replace the cutter bars by pressing down gently. Carefully replace the foil
head, snapping it into place.
From time to time, depending on the density of your beard, you will need to replace the
cutters and foils. If you notice that it is taking you longer to shave, or if your face starts to
feel some irritation, or if the foil seems to become warm to the touch, it is probably time
to replace the cutters and foils. Replace the cutters and foils only with WAHL parts
(Yellow: 7045-100, Silver: 7045-400, Black Chrome: 7045-700).
FOIL & BLADE CARE
Trimmer blades have precision-hardened, ground and lapped cutting teeth. Foils, cutter
bar, and blades should be handled carefully and never bumped or used to cut dirty or
abrasive material.
OILING THE FOILS & CUTTER BAR
Oil lubrication helps maintain smooth blade movement and shaving performance.If the
shaver is regularly cleaned under water. The Foils should be oiled at least once per
week.Use clipper oil or shaver oil.
Instructions: When foils and blades are clean and dry, apply a drop of oil to the top of each
foil and on top of the center cutter bar. Use finger to gently spread the oil over the surface.
Turn the shaver on for 10 seconds to help distribute the oil onto the blades below. Turn off
shaver and use a tissue or soft cloth to wipe any excess oil from the surface.
7