Publicité
Les langues disponibles
Les langues disponibles
16
Where to place the receiver
• Place the Stegos RS receiver in the same room where the transmission takes place. Make sure that the
receiver is placed on the same table height as the Stegos TB boundary microphone.
• Avoid shadowing effect of the Stegos RS antennae, especially by metallic surfaces.
• A free line of sight between the Stegos RS receiver and the Stegos TB microphone is ideal. Big
obstacles in between can possibly affect the radio transmission. In such specific installations the use
of remote antennae can possibly achieve an improvement of the RF situation.
How to connect the antennae
• Connect the antennae to the antenna sockets µ.
Please note that for diversity operation both antennae have to be connected. A weighting circuit
silently makes sure that the better antenna signal is received.
Connections
• Connect the Stegos RS receiver to your video conference system. There are three different connections:
3-pin Phoenix terminal strip
For a correct connection to your video conference system, please refer to the manufacturer's manual
of the video conference system regarding microphone connection.
• Via the 12-pin Phoenix terminal strip ¹ you can pickup all four microphone signals separately. This
kind of application requires optional hardware for signal processing, and is in general not necessary
for the use of Stegos.
• Connect the power cable to the mains connection
Operation
• Turn on the receiver with the on/off switch
• The channel LEDs 1 to 4 will illuminate green to indicate the availability. As soon as you turn on the
first Stegos TB boundary microphone, the channel LED 1
channel is occupied. At maximum four Stegos TB microphone can be operated simultaneously.
• The RF band "Low" is factory-adjusted.
2.1.1 How to operate Stegos with a PC
• If you want to control or monitor the system via PC, connect the USB port
the separate "Stegos" manual on the supplied CD. You will also find the latest version of the Stegos
software in the internet at www.beyerdynamic.com.
Installation of the Stegos software
• Connect the Stegos RS receiver
• Turn on the PC.
• Insert the CD-ROM with the Stegos Software into the CD-ROM drive, select "Setup.exe" and install
the software into the requested directory on the hard drive.
• Follow the instructions of the installation program when required.
• Connect the USB port
of your PC.
2.1.2 How to operate Stegos with a media control system
• If you want to control or monitor the system with a media control system, connect the RS 232 inter-
face ¸ via an optional null-modem cable to your media control system.
• Control protocols and modules are available at beyerdynamic on request.
All manuals and user guides at all-guides.com
, mini jack (3.5 mm)
and the PC to the mains.
or the RS 232 interface ¸ of the Stegos RS receiver to the appropriate port
Stegos – Quick Start Guide
, 3-pin XLR
and to the power socket.
. The green power on LED
will illuminate red to indicate that the
will illuminate.
to a PC. Refer also to
Publicité
