Publicité
Les langues disponibles
Les langues disponibles
● Install the pipe lining (provided on site) in the chim-
ney. The connection height can be individually spec-
not exceed 1.5 m from the connector sleeve. For the
rear stovepipe connection heights please refer the
"Technical Data" chapter. No combustible material is
permitted within a radius of 20 cm around the stove
pipe.
● Connect the stovepipe at both connection points
with stove putty so that the stove pipe is permanent-
ly sealed.
ified for a top stovepipe connection, however should
● Push the stove onto its planned position and orient it
The stovepipe connections must be tight. The
stovepipe must not protrude into the chimney.
Bear in mind that on partition walls in accordance
of 85°C can be reached, and with light wallpaper
or similar combustible construction materials this
can result in colour changes.
Water Installation
so that the stovepipe fits into the pipe lining.
Important
with test specification EN 13240 the temperature
● The respective locally-applicable regulations and
rules must be observed.
● The installation of water connections and all electri-
● We recommend using the following Olsberg com-
ponents for connecting the respective items to the
heating and/or industrial water system:
- Installation unit
- Temperature difference controller
Please follow the separate assembly and operation
instructions for these components.
● According to EN 12828 a safety relief valve with a
cal work must be completed by certified specialists.
314, 513 or 514) needs to be installed on site to en-
sure that the operating pressure will not exceed the
maximum of 2.5 bar.
● In addition to the requisite safety components, a re-
(the Olsberg "Installation unit" includes such a valve).
fixed response pressure setting of 2.5 bar (Flamco,
● The stove must never be operated without water.
type Prescor or Caleffi, model series 311, 312, 313,
● The oven must never be operated without a correct-
ly-installed and functional "Thermal discharge safety
be installed upstream from the TAS.
● An outlet valve must be installed in the lower section
turn flow booster valve must be installed, which in-
creases the return flow temperature to at least 55°C
of the water circulation system.
● To keep the stove and, in particular, the „Thermal
discharge safety device (TAS)" in fully operational
condition, it is essential that the heating system be
(Heating systems in buildings - Installation and
device" (TAS). Preparations also require that a filter
cleaned by flushing as specified in DIN EN 14336
All manuals and user guides at all-guides.com
commissioning of water-based heating systems) be-
fore the stove is connected hydraulically.
Olsberg cannot process any warranty claims unless
provided with proof that the necessary cleaning has
been carried out.
● An inspection must be carried out once a year to de-
termine whether the "Thermal discharge safety de-
vice" (TAS) is working properly. A press on the red
a year.
Thermal discharge safety device (TAS)
The TAS inlet must be connected to the building's cold
water system; water from the TAS outlet must be al-
button at the valve releases the flow. Check and
clean the filter at the cooling water inlet at least once
The TAS must prevent the heater from overheating
when the heat being generated cannot be removed by
the water. Overheating would cause impermissibly high
temperatures and pressures which would result in ir-
reparable consequences for the stove. In order to pre-
vent this, the TAS' safety valve will open depending on
the water temperature in the stove's heat exchanger
(sensor pocket for TAS) to allow cold tap water to re-
lowed to flow directly into the drain.
move the heat.
Do not add any more wood in the event of any such
malfunctioning.
17
Publicité
