Publicité
Les langues disponibles
Les langues disponibles
English
introduction
Congratulations on your purchase and welcome to Philips!
To fully benefit from the support that Philips offers, register your product
at www.philips.com/welcome.
general description (Fig. 1)
A Spout
B Lid
C Lid latch
D Power-on light
E On/off switch (I/O)
F Base
g Water-level indicator
h Scale filter
important
Read this user manual carefully before you use the appliance and save it for
future reference.
Danger
-
Do not immerse the appliance or the base in water or any other liquid.
Warning
-
Check if the voltage indicated on the appliance corresponds to the local
mains voltage before you connect the appliance.
-
Do not use the appliance if the plug, the mains cord, the base or the
appliance itself is damaged.
-
If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualified persons in
order to avoid a hazard.
-
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety.
-
Children should be supervised to ensure that they do not play with
the appliance.
-
Keep the mains cord out of the reach of children. Do not let the
mains cord hang over the edge of the table or worktop on which the
appliance stands. Excess cord can be stored in or around the base of
the appliance.
-
Do not place the appliance on an enclosed surface (e.g. a serving tray),
as this could cause water to accumulate under the appliance, resulting
in a hazardous situation.
-
Hot water can cause serious burns. Be careful when the kettle contains
hot water.
-
Do not touch the body of the kettle during and some time after use,
as it gets very hot. Always lift the kettle by its handle.
-
Never fill the kettle beyond the maximum level indication. If the kettle
has been overfilled, boiling water may be ejected from the spout and
cause scalding.
-
Do not open the lid while the water is heating up. Be careful when
you remove the lid immediately after the water has boiled: the steam
that comes out of the kettle is very hot.
-
HD4657 only: this rapid-boil kettle can draw up to 13 amps from the
power supply in your home. Make sure that the electrical system in your
home and the circuit to which the kettle is connected can cope with
this level of power consumption. Do not let too many other appliances
draw power from the same circuit while the kettle is being used.
-
Only use the kettle in combination with its original base.
Caution
-
Always place the base and the kettle on a dry, flat and stable surface.
-
The kettle is only intended for boiling water. Do not use it to heat up
soup or other liquids or jarred, bottled or tinned food.
-
Always make sure you fill the kettle at least up to the bottom water
level indication to prevent the kettle from boiling dry.
-
Depending on the hardness of the water in your area, small spots may
appear on the heating element of your kettle when you use it. This
phenomenon is the result of scale build-up on the heating element and
on the inside of the kettle over time. The harder the water, the faster
scale builds up. Scale can occur in different colours. Although scale is
harmless, too much scale can influence the performance of your kettle.
Descale your kettle regularly by following the instructions given in
chapter 'Descaling'.
-
Some condensation may appear on the base of the kettle. This is
perfectly normal and does not mean that the kettle has any defects.
All manuals and user guides at all-guides.com
1 staff kitchen areas in shops, offices and other working environments;
2 farm houses;
3 by clients in hotels, motels and other residential type environments;
4 bed and breakfast type environments.
This kettle is equipped with boil-dry protection. The boil-dry
protection automatically switches off the kettle if it is accidentally switched
on when there is no water or not enough water in it. The on/off switch stays
in 'on' position and the power-on light stays on. Set the on/off switch to
'off ' and let the kettle cool down for 10 minutes. Then lift it from its base to
reset the boil-dry protection. The kettle is now ready for use again.
This Philips appliance complies with all standards regarding electromagnetic
fields (EMF). If handled properly and according to the instructions in this
user manual, the appliance is safe to use based on scientific evidence
available today.
-
-
-
Note: Make sure that the lid is closed properly to prevent the kettle from
boiling dry.
, The power-on light goes on.
, The kettle starts heating up.
, You hear a bell sound when the water boils.
, The kettle switches off automatically and the power-on light goes out.
Note: You can interrupt the boiling process at any time by setting the on/off
switch to O.
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the appliance.
Never immerse the kettle or its base in water.
Scale is not harmful to your health but it may give your drink a powdery
taste. The scale filter prevents scale particles from ending up in your drink.
Clean the scale filter regularly. Models with a triple-action filter have also
been equipped with a mesh that attracts scale from the water.
Clean the scale filter in one of the following ways:
-
-
-
Regular descaling prolongs the life of the kettle.
In case of normal use (up to 5 times a day), we recommend the following
descaling frequency:
-
-
Boil-dry protection
Electromagnetic fields (EMF)
Before first use
Remove stickers, if any, from the base or the kettle.
1
Place the base on a dry, flat and stable surface.
2
To adjust the length of the cord, wind part of it round the reel in the
3
base. Pass the cord through one of the slots in the base (Fig. 2).
Rinse the kettle with water.
4
Fill the kettle with water up to the MAX indication and let the water
5
boil once (see chapter 'Using the appliance').
Pour out the hot water and rinse the kettle once more.
6
Using the appliance
Fill the kettle with water either through the spout or through the
1
open lid (Fig. 3).
Use the lid latch to open the lid (Fig. 4).
Fill the kettle at least up to the bottom water level indication.
Close the lid before you switch on the kettle.
Place the kettle on its base and put the plug in the wall socket.
2
Set the on/off switch to I to switch on the kettle (Fig. 5).
3
Cleaning
Unplug the appliance.
1
Clean the outside of the kettle with a soft cloth moistened with
2
warm water and some mild cleaning agent.
Clean the removable scale filter regularly.
3
Take the scale filter out of the kettle and gently clean it with a soft nylon
brush under a running tap (Fig. 6).
Leave the scale filter in the kettle when you descale the whole
appliance.
Clean the scale filter in the dishwasher.
Descaling
Once every 3 months for soft water areas (up to 18dH).
Once every month for hard water areas (more than 18dH).
Fill the kettle with white vinegar (8% acetic acid) up to three-quarters
1
of the MAX indication.
Publicité
