Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
10
INSTALLATION
Unpacking Your Refrigerator
WARNING
Use two or more people to move and
install the refrigerator. Failure to do so
can result in back or other injury.
Your refrigerator is heavy. When moving
the refrigerator for cleaning or service,
be sure to protect the floor. Always pull
the refrigerator straight out when mov-
ing it. Do not wiggle or walk the refrig-
erator when trying to move it, as floor
damage could occur.
Keep flammable materials and va-
pors, such as gasoline, away from the
refrigerator. Failure to do so can result
in fire, explosion, or death.
Remove tape and any temporary labels from
your refrigerator before using. Do not remove
any warning-type labels, the model and serial
number label, or the circuit diagram that is located
in the back of the refrigerator
Please remove vinyl from door before connecting
electrical supply. (on some models)
To remove any remaining tape or glue, rub
the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing
a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to re-
move tape or glue. These products can damage
the surface of your refrigerator.
Refrigerator shelves are installed in the ship-
ping position. Please reinstall shelves according
to your individual storage needs.
Choosing the Proper Location
Select a place where a water supply can
be easily connected for the automatic
icemaker.
NOTE
The water pressure must be between 20
and 120 psi (
-
Pa) on models
without a water filter and between 40 and
120 psi (
-
Pa) on models with a
water filter.
The refrigerator should always be plugged
into its own individual properly grounded
electrical outlet according the National
Rating on the product characteristic you
purchased rated for 115 - 127 v, 60 Hz or 220
v, 50/60 Hz. AC only, and fused at 15 or 20
amperes.This provides the best perfor-
mance and
also
prevents
house wiring circuits which could cause a
fire hazard from overheated wires. It is
recommended
that
serving only this appliance be provided.
WARNING
To reduce the risk of electric shock, do not
install the refrigerator in a wet or damp area.
Flooring
To avoid noise and vibration, the unit must be
leveled and installed on a solidly constructed
floor. If required, adjust the leveling legs to
compensate for unevenness of the floor. The
front should be slightly higher than the rear to
aid in door closing. Leveling legs can be turned
easily by tipping the cabinet slightly. Turn the
leveling legs to the left to raise the unit or to
the right to lower it. (See Leveling and Door
AlIgnment.)
NOTE
Installing on carpeting, soft tile surfaces, a
platform or weakly supported structure is
not recommended.
overloading
a
separate circuit
Publicité
