Camera Setup - Kenwood DNX9280BT Guide De Démarrage Rapide

Masquer les pouces Voir aussi pour DNX9280BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Panel Color Coordinate
SET
Initialize
Panel Color Scan
• When touching [SET] or [Initialize], make sure [Panel Color Scan] is set to "OFF".
EXT SW Setup
SW1 Name/ SW2 Name
Output Pattern
Pulse Set

Camera Setup

Rear Camera
R-CAM Interruption
Front Camera
Select a color
[Blue] ... [White] Sets the selected color.
[Adjust] Sets and registers favorite color to the preset buttons ([Preset1] – [Preset3]).
Initialization resets the settings made using the Panel Color SET process to the default settings set
at the factory.
When set to "ON", the illumination color of the buttons changes one after another.
Returns to the previous screen.
Sets the name of the external device.
Sets the power signal output mode. (Preset: EXT SW1: "Pulse", EXT SW2: "Level")
"Pulse": Generates a single power signal pulse. (
"Level": Continues output of high power signal. (
Sets to turn output on/off each time the button on the EXT SW Control screen is touched.
Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases by 200ms with each step. Up to 100 steps can be set.
Returns to the previous screen.
Selects the type of rear camera to use. (Preset: "Other")
"CMOS-300": When the CMOS-300 with ID 1 set is connected. When setting to "CMOS-300",
camera adjustment screen appears. For the adjustment method, refer to the manual
of CMOS-300.
"Other": When the other camera is connected.
Sets a method to switch to the rear view camera video display. (Preset: "OFF")
"ON": Switches to the rear view camera video display when engaging the shift knob of car to
"Reverse".
"OFF": Switches to the rear view camera video display, press the [AUD] button for longer than 1
second. The function of the [AUD] button needs to be set to "CAM" in [AUD Key Longer
than 1 Second] beforehand.
Turn this setting on when the CMOS-300 with ID2 set is connected. When setting to "ON", camera
adjustment screen appears. For the adjustment method, refer to the manual of CMOS-300.
Returns to the previous screen.
)
)
English | 7

Publicité

Table des Matières
loading

Table des Matières