AVS Bugflector Instructions D'installation page 2

Installation Steps
Rotate rubber seal back into position over
hood shield flange and align with holes in hood
3
Install bump ons at pre-cleaned locations on the hood surface where the hood shield
5
Care and Cleaning
•
Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost
pride in our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your
product is top quality in terms of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
shield.
may contact.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Install (1) washer and screw and tighten until
snug. Repeat for remaining (3) fasteners.
4
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
DO NOT OVER TIGHTEN
hood
hood shield
rubber seal
washer
screw