Télécharger Imprimer la page

Black & Decker PKS210 Mode D'emploi page 2

Publicité

Les langues disponibles

Les langues disponibles

Attaching Accessories
Note: Do not attach/remove accessory when unit is running.
1. To connect an attachment, line up the shape of the end of the accessory with the shaft
and push it on, until it snaps in place.
2. To remove an attachment, simply pull it off.
How to Operate Switch
1. To operate, push the Switch (Fig. A, 3) in to turn on. Press the Switch in again to
turn off. To avoid splatter from a Brush or Pad, turn the scrubber off while the
attachment is still in contact with the surface.
2. Because this scrubber is powerful, you don't have to apply excessive pressure while
operating. Use a circular motion on large areas.
Tips on Cleaning Agents
IMPORTANT: The palm grip power scrubber has been designed for easy, powerful
cleaning. If you are uncertain about its use on a surface, test an attachment on a
small inconspicuous area before cleaning larger areas.
• Always follow manufacturer's recommendations when using a chemical cleaner such as
sprays, foams, rub-on gels, liquid detergents, or bleach solutions.
• Cleaners with abrasives can damage some surfaces. Use a cleaner that is appropriate for
the surface being cleaned. Test the cleaner on a small, inconspicuous area if uncertain.
• Always wear rubber gloves and protective eye wear (to avoid splatter) when using irritating
cleaners.
Cleaning and Storage
1. Clean the Brushes and Scrub Pads in a mild detergent, rinse with water and air dry.
You may rinse any attachments/accessories by dipping the scrubber into a bucket of
water no more than 12 inches (30 cm) deep or running under a faucet. Do not leave
immersed for more than 5 minutes.
2. To clean the scrubber unit, wipe with a damp sponge and a mild soap.
3. Store the scrubber and attachments/accessories indoors.
Battery Removal and Disposal
This product uses a nickel-cadmium (Ni-Cad) rechargeable and recyclable battery.
When it can no longer be recharged, it should be removed from the unit and recycled.
The battery must not be incinerated or composted. The battery can be taken for disposal to
a Black & Decker Inc.,Company-Owned or Authorized Service center. There are also some
local retailers who are participating in a national recycling program (see "RBRC Seal").
Call your local retailer for details. If you bring the old battery to a Black & Decker Company
Owned or Authorized Service Center, the Center will arrange for recycling it. Or, if you wish,
contact your local municipality for proper disposal instructions in your city/town.
Battery Removal - Fig. F
1. Remove the three screws from the underside of the unit using a phillips screw driver.
Remove the cap by pulling up as shown. (Fig. F, 1)
2. Loosen the wires out of the notches and slide the switch out. (Fig. F, 2)
3. Disconnect the battery pack terminals. Lift and rotate the motor/battery assembly up out
of the lower housing. (Fig. F, 3)
4. Straighten the battery pack wires to allow it to be slid out of the tool as shown. (Fig. F, 4)
Dispose of the battery as noted above.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
nickel-cadmium battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Black & Decker. In some areas, it is illegal to place spent nickel-cadmium batteries in the
trash or municipal solid waste stream and the RBRC program provides an environmentally
conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent
el-cadmium batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized Black & Decker service center
or to your local retailer for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery, or call 1-800-8-BATTERY.
Service Information
Black & Decker offers a full network of company-owned and authorized service locations
throughout North America. All Black & Decker Service Centers are staffed with trained
personnel to provide customers with efficient and reliable power tool service.
Whether you need technical advice, repair, or genuine factory replacement parts, contact
the Black & Decker location nearest you.
To find your local service location, refer to the yellow page directory under "Tools–Electric"
or call: 1-800-54-HOW TO (544-6986) or visit www.blackanddecker.com.
Full Two-Year Home Use Warranty
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in
material or workmanship. The defective product will be replaced or repaired at no charge in
either of two ways:
The first, which will result in exchanges only, is to return the product to the retailer from
whom it was purchased (provided that the store is a participating retailer). Returns should
be made within the time period of the retailer's policy for exchanges (usually 30 to 90 days
after the sale). Proof of purchase may be required. Please check with the retailer for their
specific return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or
authorized Service Center for repair or replacement at our option. Proof of purchase may be
required. Black & Decker owned and authorized service centers are listed under
"Tools–Electric" in the yellow pages of the phone directory.
This warranty does not apply to accessories. This warranty gives you specific legal rights
and you may have other rights which vary from state to state. Should you have any
questions, contact the manager of your nearest Black & Decker Service Center. This
product is not intended for commercial use.
Free warning label replacement: If your warning labels become illegible or are missing,
call 1-800-544-6986 for a free replacement.
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
All manuals and user guides at all-guides.com
• Lors de l'immersion de la brosseuse dans l'eau, ne pas couvrir l'appareil
directives importantes
Lors de l'utilisation d'appareils électriques, toujours respecter les mesures
de sécurité de base, notamment les suivantes :
LIRE ATTENTIVEMENT ET COMPRENDRE TOUTES LES DIRECTIVES AVANT
nick-
D'UTILISER L'APPAREIL.
• Exercer une étroite surveillance pour l'utilisation de tout appareil électrique par des enfants
• Pour se protéger contre le risque d'électrocution, ne pas immerger le chargeur de pile ou la
• Ne pas utiliser l'appareil en présence de vapeurs ou de liquides explosifs ou inflammables.
• Toujours porter une protection oculaire lorsque la brosseuse est utilisée avec des
• Toujours ranger l'appareil à l'intérieur.
• Éloigner les cheveux, vêtements amples et toutes les parties du corps de tous composants
• Ne pas installer ou retirer d'accessoires/pièces lorsque l'appareil fonctionne.
• Ranger l'appareil hors de la portée des enfants.
• Pour réduire le risque d'incendie ou de choc électrique, ne pas utiliser un appareil
• Ne pas installer la base de charge assemblée au-dessus ou près de toute portion
• Ne pas installer l'appareil derrière, sous ou devant le système d'éclairage de l'armoire.
• L'appareil électrique est conçu pour une utilisation domestique seulement et non
• Utiliser l'appareil uniquement selon les indications données dans le présent manuel.
Directives de sécurité importante pour la pile et le
chargeur
See 'Tools-Electric'
• Ne pas charger une pile mouillée ou qui affiche des signes de corrosion.
– Yellow Pages –
• Ne pas incinérer la pile. Elle peut exploser dans un feu. Une petite fuite peut se produire
for Service & Sales
• Ne pas utiliser de rallonge. Brancher le chargeur directement dans la prise électrique.
• Le brancher seulement dans une prise électrique standard (120 v, 60 Hz).
• Ne pas utiliser le chargeur avec un autre produit; ni tenter de charger le produit avec un
• Ne pas utiliser le chargeur dans des conditions mouillées ou humide. Il est conçu
• Ne pas laisser le cordon reposer contre le bord d'une table ou d'un comptoir ou sur une
BROSSEUSE ÉLECTRIQUE À PRISE
BROSSEUSE ÉLECTRIQUE À PRISE
P
ALMAIRE
P
ALMAIRE
MODE D'EMPLOI
M
M
'
'
ERCI
ERCI
D
D
A
A
VOIR
VOIR
CHOISI
CHOISI
V
.B
V
.B
ISITEZ
WWW
LACKAND
ISITEZ
WWW
LACKAND
POUR
ENREGISTRER
POUR
ENREGISTRER
AVANT DE RETOURNER CE PRODUIT POUR QUELQUE
RAISON QUE CE SOIT, COMPOSER LE
1-800-544-6986
AVANT D'APPELER, AYEZ EN MAIN LE N° DE CATALOGUE ET LE CODE DE DATE. DANS LA PLUPART DES
CAS, UN REPRÉSENTANT DE BLACK & DECKER PEUT RÉSOUDRE LE PROBLÈME PAR
TÉLÉPHONE. SI VOUS AVEZ UNE SUGGESTION OU UN COMMENTAIRE, APPELEZ-NOUS. VOS
IMPRESSIONS SONT CRUCIALES POUR BLACK & DECKER.
Voici des renseignements importants à connaître :
avec plus de 1 mètre (3 pieds) d'eau. Ne pas immerger la brosseuse
pendant plus de 30 minutes.
CONSERVER CE MANUEL POUR UN USAGE ULTÉRIEUR.
AVERTISSEMENT : avertissements de sécurité et
AVERTISSEMENT :
certains produits de nettoyage contiennent des produits
chimiques reconnus par l'État de Californie comme pouvant
causer le cancer, des anomalies congénitales ou d'autres
problèmes liés aux fonctions reproductrices. Lors de
l'utilisation de la brosseuse électrique à prise palmaire,
s'assurer de lire les étiquettes des produits nettoyants et à
rechercher tout avertissement lié à l'article 65. Suivre les
directives mentionnées sur les récipients de tels produits.
AVERTISSEMENT :
pour réduire les risques d'incendie, de chocs électriques ou
de blessures :
ou à proximité de ceux-ci. Interdire l'utilisation de l'appareil comme jouet.
base de charge dans l'eau ou autre liquide.
substances irritantes. Utiliser également des gants en caoutchouc, le cas échéant. Lire et
suivre les directives du fabricant à propos du produit nettoyant utilisé. N'utiliser que des
nettoyants domestiques.
mobiles.
électrique de chauffage sous la base de charge assemblée.
d'appareil de chauffage ou de cuisinière ou d'un évier ou bassin.
commerciale ou industrielle.
Utiliser uniquement les accessoires recommandés par Black & Decker.
dans la cellule de la pile en cas d'utilisation, de charge ou de conditions de température
extrême(s). Cela n'indique pas de défaillance. Toutefois, si le joint d'étanchéité extérieur est
rompu et que la fuite entre en contact avec la peau : (1) laver immédiatement à l'eau et au
savon ou (2) neutraliser à l'aide d'un acide doux comme du jus de citron ou du vinaigre (3) si
le liquide atteint les yeux, les rincer immédiatement à l'eau claire pendant au moins dix
minutes Consulter un médecin.
REMARQUE : Le liquide est composé d'une solution de 20 % à 35 % d'hydroxyde de
potassium.
autre chargeur. Utiliser uniquement le chargeur fourni par le fabricant.
(chargeur n° 90505774)
uniquement pour une utilisation à l'intérieur. Ne pas utiliser le chargeur près d'éviers ou de
baignoires. Ne pas immerger dans l'eau.
surface chaude. Installer le chargeur loin d'éviers et de surfaces chaudes.
Numéros de catalogue :
PKS210, PKS210B
B
B
& D
& D
!
!
LACK
LACK
ECKER
ECKER
D
.
/N
O
D
.
/N
O
ECKER
COM
EW
WNER
ECKER
COM
EW
WNER
VOTRE
NOUVEAU
PRODUIT
VOTRE
NOUVEAU
PRODUIT
.
.

Publicité

loading

Ce manuel est également adapté pour:

Pks210b