Xerox CopyCentre C118 Guide D'installation page 5

Network Setup Using a Static IP Address
When the machine is powered on, it automatically uses DHCP to obtain its network configuration. To use a
static IP address, DHCP must be turned off and the IP address, gateway address, subnet mask, and
DNS Server address must be entered manually.
Pre-Requisites for Using a Static IP Address
Before you begin, obtain the following information from your network administrator:
IP Address:
Gateway Address:
Subnet Mask:
DNS Server Address:
Connecting the Machine Using a Static IP Address
1.
Turn on the machine.
2.
When the machine is Ready, press the Log In/Out button.
3.
Press the Select button below the display to select
a. Use the numeric keypad to enter the Password. The default password is 11111.
b. Press the Select button to select Confirm.
Turn DHCP Off
1. Press the Select button to highlight
2. Press the the Enter button to select Network/Port.
3. Press the Select button until you see
4. Get IP Address, and then press the Enter button.
Select
5. Select Manual, and then press the Enter button.
6.
Press the Exit button.
All manuals and user guides at all-guides.com
__________ . __________ . __________ . __________
__________ . __________ . __________ . __________
__________ . __________ . __________ . __________
__________ . __________ . __________ . __________
System
Print Settings, and then press the Enter button.
TCP/IP Settings
Xerox WorkCentre M118/M118i
3
Network Setup Using a Static IP Address
Settings.
on the display, and then press the Enter button.