Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water
flows
on
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working properly
after making the above checks, contact the Af-
ter Sales Centre. You can find the list at the end
of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Press on the
rear hook of the
lamp cover by a
screwdriver (1)
and
at
the
same time pull
and rotate the
cover (2) in the
direction of the
arrow.
Possible cause
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
the
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is
not set correctly.
1
2
Solution
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower temperature.
2. Replace the lamp with one of the same
power (the maximum power is shown on
the lamp cover).
3. Install the lamp cover by fixing it into its
original position.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
12
Publicité
