Publicité
Les langues disponibles
Les langues disponibles
9. Stand back from the vehicle and check to see that the Bull Bar is centered and level on the vehicle and
adjust as necessary. Fully tighten first the hardware securing the mounting brackets to the vehicle. Next
tighten only the (4) 8mm Hex Bolts securing the tube brackets to the Bull Bar as described in Step 7. Do
not tighten the 12mm hardware attaching the tube brackets to the mounting brackets.
10. Temporarily remove the Bull Bar with tube brackets attached.
11. Hold the plastic air dam up to the bumper and align it with the mounting points. Mark the location of the
mounting brackets onto the back of the air dam, (Figure 8). Cut an approximately 1-1/2" wide slot out of
the bottom of the air dam. NOTE: The size of the slot is an estimate only and may vary due to different
factory designs for the air dam and front bumper covers. IMPORTANT: To avoid weakening the air dam,
do not cut the slot any larger than necessary to clear brackets only. Do not cut through the top edge or
mounting points, (Figure 8). Make several small cuts first and check the fit often for a clean installation.
12. Reinstall the air dam using the factory hardware. NOTE: It may be necessary to loosen the bracket
hardware to reinstall the air dam.
13. Reinstall the Bull Bar as described in Step 8.
14. Level and adjust the Bull Bar and fully tighten all hardware.
15. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used to clean the Bull Bar.
Front
Body bolt
(Fig 1) Driver/left mounting location
pictured from behind bumper
Driver Side Installation Pictured
Page 3 of 5
I-Sheet Number 10894 Rev.A
8mm Bolt Plate
8mm Plastic Retainer
Front
(Fig 2) Insert Bolt Plate back
through bumper bracket (arrow)
3.5" OVAL BULL BAR
2019 RAM 1500
Remove the (2)
factory hex bolts
07/20/18 (DP)
Publicité
