LUND 47121208 Instructions D'installation

PARTS LIST:
1 3.5in Bull Bar
1 Driver/Left Side Frame Mounting Bracket
1 Passenger/Right Side Frame Mounting Bracket
2 Tube Brackets (passenger and driver side)
1 Driver/Left Side Support Bracket
1 Passenger/Right Side Support Bracket
2 8mm x 30mm Bolt Plates
2 8mm Plastic Retainers
4 12-1.75mm x 35mm Hex Bolts
Passenger/right
Frame Bracket
Passenger/Right
Support Bracket
(2) Tube Brackets
EQUIPMENT NEEDED:
Safety Glasses
•
Ratchet Set
•
Pliers or Adjustable Wrench
•
IMPORTANT NOTES:
Bull Bar may interfere with parking sensors on the bumper.
•
The LED light car can be wired into the factory lighting, or a wiring harness can be purchased
•
separately,
IF state law requires a front license plate, a relocation kit is available separately.
•
Mild soap may be used to clean the Bull Bar and aluminum polish may be used on the stainless steel to
•
polish small scratches and scuffs on the finish.
8
4
4
4
6
14
12
4
1
Lightbar
(2) 8mm Bolt Plates
(2) 8mm Plastic Retainers
Page 1 of 5
I-Sheet Number 10894 Rev.A
12mm x 32mm OD x 3mm Flat Washers
12mm Lock Washers
12mm Hex Nuts
8-1.25mm x 35mm Hex Bolts
8-1.25mm x 30mm Hex Bolts
8mm x 24mm OD x 2mm Flat Washers
8mm Lock Washers
8mm Hex Nuts
LED Lightbar
3.5" OVAL BULL BAR
2019 RAM 1500
Driver/left Frame
Bracket
Driver/left
Support Bracket
07/20/18 (DP)