Makita 6510LVR Manuel D'instructions page 3

ENGLISH
1 Tighten
2 Sleeve
3 Ring
SPECIFICATIONS
Model
Capacities
Steel ............................................................ 10 mm
........................................................... 18 mm
Wood
No load speed (RPM) ................................ 0 – 1,050
Overall length ............................................... 242 mm
Net weight ..................................................... 1.48 kg
• Due to the continuing program of research and
development, the specifications herein are subject
to change without prior notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a power
supply of the same voltage as indicated on the
nameplate, and can only be operated on single-phase
AC supply. They are double-insulated in accordance
with European Standard and can, therefore, also be
used from sockets without earth wire.
Safety hints
For your own safety, please refer to enclosed safety
instructions.
These symbols mean:
Read instruction manual.
DOUBLE INSULATION
ADDITIONAL SAFETY RULES
1. Always be sure you have a firm footing. Be
sure no one is below when using the machine
in high locations.
2. Hold the machine firmly.
3. Keep hands away from rotating parts.
4. When drilling into walls, floors or wherever
''live'' electrical wires may be encountered, DO
NOT TOUCH ANY METAL PARTS OF THE
MACHINE! Hold the machine by the insulated
grasping surfaces to prevent electric shock if
you drill into a ''live'' wire.
5. Do not leave the machine running. Operate the
machine only when hand-held.
6. Do not touch the drill bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
All manuals and user guides at all-guides.com
Explanation of general view
4 Low
5 High
6 Speed control screw
6510LVR
7 Switch trigger
8 Lock button
9 Reversing switch lever
OPERATING INSTRUCTIONS
Installing or removing drill bit (Fig. 1)
Important:
Always be sure that the machine is switched off and
unplugged before installing or removing the bit.
Hold the ring and turn the sleeve counterciockwise to
open the chuck jaws. Place the bit in the chuck as far
as it will go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck. To remove the bit, hold
the ring and turn the sleeve counterclockwise.
Switch action (Fig. 2)
CAUTION:
Before plugging in the machine, always check to see
the switch trigger actuates properly and returns to the
''OFF'' position when released.
To start the machine, simply pull the trigger. Machine
speed is increased by increasing pressure on the
trigger. Release the trigger to stop. For continuous
operation, pull the trigger and then push in the lock
button. To stop the machine from the locked position,
pull the trigger fully, then release it. A speed control
screw is provided so that maximum machine speed
can be limited (variable). Turn the speed control
screw clockwise for higher speed, and counterclock-
wise for lower speed.
Reversing switch action (Fig. 3)
CAUTION:
• Always check the direction of rotation before drilling.
• Use the reversing switch only after the machine
comes to a complete stop. Changing the direction of
rotation before the machine stop may damage the
machine.
This machine has a reversing switch to change the
direction of rotation. Move the reversing switch lever
to the position for clockwise rotation or
the position for counterclockwise rotation.
3