Dell PowerEdge 4220 Guide D'installation page 9

Rack Stabilizer Feet
The stabilizer feet help prevent the rack from tipping over when a system or
other component is pulled out of the rack with the slide assemblies fully
extended.
Installation Tasks
Installing a rack cabinet involves performing the following tasks:
1 Removing and replacing the rack doors
2 Removing and replacing the side panels
3 Reversing the front door and badge (optional)
4 Securing the leveling feet
5 Installing the stabilizer feet
6 Adjusting the rack posts (optional)
7 Routing cables through the rack
8 Coupling two racks (optional)
Recommended Tools and Supplies
You may need the following tools and supplies to install the rack:
•
•
•
•
•
•
•
•
Get user manuals: See SafeManuals.com
WARNING:
Installing systems in a rack without the front and side stabilizer feet
installed could cause the rack to tip over, potentially resulting in bodily injury
under certain circumstances. Therefore, always install the stabilizer feet before
installing components in the rack.
WARNING:
After installing systems in a rack, never pull more than one system
out of the rack on its slide assemblies at one time. The weight of more than one
extended system could cause the rack to tip over and cause injury.
#2 Phillips screwdriver
Flat head screwdriver
12-mm wrench
Needle-nose pliers
4-mm Allen wrench (if you want to reverse the direction that the front
door opens)
Keys to the rack doors and side panels
13-mm wrench (for rack removal from pallet)
17-mm wrench (for rack removal from pallet)
Installation Guide
7