Connecting The Antennas; Connecting The Am Loop Antenna - Onkyo CS-355 Manuel D'instructions

Connecting the Antennas

This section explains how to connect the supplied indoor FM antenna and AM loop antenna.
The CD receiver won't pick up any radio signals if no antenna is connected, so you must connect the antenna to use the
tuner.
Connecting the Indoor FM Antenna
Insert the plug fully into
the jack.
Note:
• Once your CD receiver is ready for use, you'll need to tune into a radio station and position the antenna to achieve
the best possible reception.
Tip:
• If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM
antenna instead.

Connecting the AM Loop Antenna

The supplied indoor AM loop antenna is for indoor use only.
1 Assemble the AM loop antenna, inserting
the tabs into the base, as shown.
2 Plug the AM loop
antenna into the
AM antenna jack,
as shown.
14
En-
Caution:
• Be careful not to injure yourself when using
thumbtacks.
Thumbtacks, etc.
Indoor FM antenna (supplied)
■ Adjusting the AM Loop Antenna
Adjust the location and position of
the AM antenna while listening to
an AM station to achieve the best
possible reception.