Publicité
Les langues disponibles
Les langues disponibles
Fix Duct to transition and seal with tape.
For both ins tallation method :
10. Wiring the HOOD:
WARNIN G:
To Avoid
Electrical Shock Hazard
Turn off power at the service
panel before wiring this unit .
120 VAC, 15 or 20 Amp circuit
required .
ELECTRICAL
GROUNDING INSTRUCTIONS
THIS APPLIANCE
IS FITTED WITH AN
ELECTRICAL
JUNCTION BOX WITH 3
WIRES, ONE OF WHICH (GREEN/YELLOW)
SERVES
TO GROUND THE APPLIANCE.
WARNIN G:
TO PROTECT YOU AGAINST ELECTRIC
THE GREEN AND YELLOW WIRE MUST BE
CONNECTED TO THE GROUNDING
YOUR HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUNSTANCES BE CUT OR REMOVED .
Failure to do so can result in death or
electrical shock.
Remove the j-box cover as shown in
Figure 5.
If not already done, install 1/2" conduit
connector in j-box.
Run black, white, and green wires (#14
AWG) according to the National Electrical
Code or CSA Standards and local codes and
ordinances .
Connect black, white, and green wires from
power supply to black, white, and green/
yellow wires in j-box respectively.
Close j-box cover.
Final installation steps
1. Install grease filters, lamps and drip trays as
described in the Care & Use section of this
manual .
Note : Lamps are not supplied, use ONLY 120
Volt, 50 Watt (maximum) 50° halogen light
made for a GU10 base, suitable for use in
open luminarie .
Turn power on at service panel.
All manuals and user guides at all-guides.com
SHOCK,
WIRE IN
10
From
control
panel
Figure 5
Publicité
