Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
M S-7238 M ainboard
Connectors, Jumpers, Slots
4
Fan Power Connectors
The fan power connectors support system cooling fan with +12V. The CPU FAN supports Smart FAN function. When
connect the wire to the connectors, always take note that the red wire is the positive and should be connected to the +12V,
the black wire is Ground and should be connected to GND. If the mainboard has a System Hardware Monitor chipset on-
board, you must use a specially designed fan with speed sensor to take advantage of the fan control.
Control
SENSOR
+1 2V
GND
Important
Please refer to the recommended CPU fans at AMD
Fan/heatsink with 3 or 4 pins are both available for CPUFAN.
5
Floppy Disk Drive Connector (FDD connector)
The mainboard provides a standard floppy disk drive connector that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy
disk types.
6
ATA133 Hard Disk Connector (IDE connector)
A IDE connector can connect a Master and a Slave drive. You can connect CD-ROM/ Hard Driver and other IDE devices.
The Ultra ATA133 interface boosts data transfer rates between the computer and the hard drive up to 133 megabytes (MB)
per second. The new interface is one-third faster than earlier record-breaking Ultra ATA/100 technology and is backwards
compatible with the existing Ultra ATA interface.
Important
If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. Refer
to the hard disk documentation supplied by hard disk vendors for jumper setting instructions.
Serial ATA Connector
7
SATA1.0 connector supports serial ATA data rates of 150 MB/s and will be marked in ORANGE color. SATA 2.0 connector
supports serial ATA data rates of 300 MB/s and will be marked in PURPLE color. Each SATA connector can connect to 1
hard disk device.
Serial ATA cable
Important
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise, data loss may occur during transmission.
En-6
SENSOR or NC
CPU FAN
®
official website or consult the vendors for proper CPU cooling fan.
SATA 1.0 connector (Orange)
SATA 2.0 connector (Purple)
Connect to SATA connector
+1 2V
GND
SYS FAN/ NB FAN/
POWER FAN
Take out the dust cover and connect
to the hard disk devices
Publicité
