Publicité
Les langues disponibles
Les langues disponibles
1. How to Use AC Power
1. Start the engine with no electrically powered items plugged into the generator.
2. After unit starts and the green output indicator light (see diagram #56011) illuminates you may know plug in and operate
electrically powered devices.
Substantial overloading will illuminate the red overload indictor light and damage the generator.
Marginal overloading that temporarily lights the overload indicator light (red) may shorten the service life of the
generator.
If an appliance begins to operate abnormally, becomes sluggish, or stops suddenly, turn it off immediately.
Disconnect the appliance, and determine whether the problem is the appliance, or if the rated load capacity
of the generator has been exceeded.
Output and overload indicator
At normal condition, output indicator (green light) will stay lit. If the generator is overloaded or if there is a short circuit in a connected
appliance, the overload indicator light (red) will illuminate. Then after about four seconds, current to the connected appliance(s) will
shut off, and the output indicator light (green) will go OFF.
If the red indicator light activates, please stop the engine and find out the reason for the overload.
Check your equipment for proper operation, electrical shorts, malfunctions, and make sure that the power required to operate
the desired equipment does not exceed the power available from the generator. Only then put the plug in the socket, and start the
engine.
Be sure all equipment is in the off position upon starting the generator. Only start your equipment when the green power
indicator light is illuminated and the generator is providing the necessary power to run your equipment.
If the red overload light and the green output light activate at the same time after starting engine and the red
overload indicator light stays on after the green output indicator light goes off please turn off the generator and
consult your closest authorized service center or EquipSource, LLC. @ 866-471-7464.
A. Start Engine
(refer to section 6 for instructions)
B. Wait five seconds for green power light to illuminate.
If the green output indicator light is off, and the red overload indicator light is on, stop the engine using the ignition switch, then
follow section 6 start engine requirements and restart.
14
All manuals and user guides at all-guides.com
Publicité
