Télécharger Imprimer la page

Lifan Power SineWave Storm Serie Mode D'emploi page 11

Publicité

Les langues disponibles

Les langues disponibles

IDLE CONTROL SWITCH
When there is no power requirement or load on the generators, generators go to gas-saving mode; upon demand, it will turn to
correct speed automatically in order to supply the correct power that device needs which minimizes fuel consumption and reduces
noise levels when no load is applied to the generator.
If high electrical loads are connected simultaneously, turn the Auto Idle switch to the OFF position to reduce voltage changes.
Turn the AUTO IDLE feature off when the equipment you are running requires full power at startup (ex. power tools and other
equipment with electric motors).
When generators are working at constant rated power output mode, turn off the AUTO IDLE SWITCH
Pre-Operation Check
1. Engine Oil Requirements
Operating generators with insufficient oil may damage the engine and void your warranty.
Engine oil is a major factor affecting engine performance and service life. Non-detergent and 2-stroke engine oil will
damage the engine and must not be used in your Energy Storm Generator.
Use 4-stroke motor oil that meets or exceeds the requirements for API service classification SJ. Always check the API
SERVICE
label on the oil container to be sure it includes the letter SJ.
SAE 10W-30 is recommended for general, all-temperature use. Other viscosities shown in the chart may be used when
the average temperature in your area is within the indicated range.
Note:
The Oil Alert system is designed to prevent engine damage caused by an insufficient amount of oil in the crankcase. Before the oil
level in the crankcase falls below a safe limit, the oil alert indicator light comes on and the Oil Alert system will automatically stop
the engine (the engine switch will remain in the ON position, turn it to the OFF position in this occurrence). If the engine stops or
the Oil Alert indicator light comes on when you pull the starter grip, check the engine oil level before troubleshooting in other areas.
All manuals and user guides at all-guides.com
CAUTION!
7

Publicité

loading