Heath Zenith CB-2010 Mode D'emploi

Motion Sensor
Light Control with
Protective Lamp
Shields
Model CB-2010
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
This package includes:
Lamp
Holders
Cover
Plate
Light Control
Mounting Bolt
2 Wire
Connectors
2 PAR Lamps
Requirements
• The Light Control requires 120-volts AC.
• If you want to use the Manual Mode, the control
must be wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in
wet locations.
© 2000 Heath Co. a div. of DESA International
All manuals and user guides at all-guides.com
Mounting Strap
Rubber Plug
Sensor
Plastic Hanger
Gasket
6 Screws
(3 sizes included)
OPERATION
Mode: On-Time:
Test 5 Sec
Auto 1, 5, 20 min.
Manual Until Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 12 minutes
for the circuitry to calibrate.
TEST
Put ON-TIME switch on the sensor
bottom to TEST.
AUTO
Put the ON-TIME switch in the 1, 5 or
20 minute position.
MANUAL MODE
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn
the power off for one minute, then back on. After
the calibration time the control will be in the
AUTO mode.
Works: Day Night
x x
x
x
ON-TIME
TEST 1 5 20
ON-TIME
TEST 1 5 20
1 Second OFF
then...
... back on.
Move ON-TIME Switch
to 1, 5 or 20 minutes
Flip light switch off
for one second then
back on*
598-1090-00