Panasonic DP-1520P Guide Rapide page 10

Getting To Know Your Machine
Operation Chart
■ Quick Operation Chart
Turn the Power
Adding Paper
Switch to the
ON position
● Adding Paper (Paper Tray)
The following steps are for Paper Tray-1, use the same procedures for other optional Paper Trays.
1
Paper Tray
NOTE:
When changing the paper size,
refer to page 54.
● Adding Paper (Sheet Bypass)
Copying on Special Paper, etc.
1
PUSH
Sheet Bypass
4
Width Guides
10
1
From
ADF/i-ADF
(Option)
Original Guides ∗ ∗ ∗ ∗ ∗
Adjust to the
or
original's width
∗ ∗ ∗ ∗ ∗
Hold the guides by the center when
adjusting the width
Original Guides
From
Platen
INV
INV
LTR
LGL
LTR
LDR
INV: Invoice, LTR: Letter
LGL: Legal, LDR: Ledger
2
Max Level
Indicator
Load Paper: Face Up
Paper Weight: 16 - 24 lb
Paper Capacity: 550 Sheets (20 lb)
2
Until it stops
Adjust the width guides.
Incorrect adjustment may cause the
paper to wrinkle, misfed or skew.
Face Up
Tray
(Max. 50 Letter
size originals)
INV
INV LTR LGL LDR
Face Down
● If the original is not positioned
properly, a portion of the original
may not be copied.
● For originals smaller than Invoice
size, position the original within
the Invoice area and select
Invoice.
3
NOTE:
Make sure that the paper is set
properly and that it does not exceed
the Max. Level indicator.
3
Face Down
Upper Limit Guides
Load Paper
(Do not exceed limit guides)
Paper Weight: 15-35 lb
Paper Capacity: 50 sheets/20 lb
To add paper to the Sheet Bypass,
remove the leftover paper from the
tray, and align it with the additional
paper and load them together onto the
tray.
2
If set in other
function mode
(DP-1820P/1820E
only)
Paper Tray
4
Until it stops