Publicité
Les langues disponibles
Les langues disponibles
Starting the programme
Press Start / Pause button to start the programme.
Programme follow-up light showing the startup of
the programme will turn on.
Progress of programme
Progress of a running programme can be followed
from the Programme Follow-up indicator with the
lights "Running" and "End/Cancel".
If the machine does not pass to the spinning
C
step, automatic unbalanced load detection
system might have been activated due to the
unbalanced distribution of the laundry in the
machine.
Loading door lock
There is a locking system on the loading door of the
machine that prevents opening of the door in cases
when the water level is unsuitable.
If you want to open loading door when the machine
is in use, press "Start / Pause" button to pause the
machine. "Door Open" light will start flashing when
the machine is switched to Pause mode. Machine
checks the level of the water inside. If the level
is suitable, "Door Open" light illuminates steadily
within 1-2 minutes and the loading door can be
opened.
If the level is unsuitable, "Door Open" light turns off
and the loading door cannot be opened. If you are
obliged to open the loading door when the "Door
Open" light is off, you have to cancel the current
programme; see "Cancelling the programme".
Switching the machine to pause mode
Press the "Start / Pause" button to switch the
machine to pause mode while a programme is
running. "Running" light starts flashing on the
Programme Follow-up indicator to show that the
machine has been switched to the pause mode.
When the loading door is ready to be opened,
"Door Open" light will illuminate continuously.
Adding or taking out laundry
Press "Start / Pause" button to switch the machine
to pause mode. When the machine is switched to
pause mode, "Running" light flashes. Wait until the
Loading Door can be opened. Open the Loading
Door and add or take out the laundry.
Close the Loading Door. Press "Start / Pause"
button to start the machine.
The door can be opened if the water level is
C
suitable. Door open symbol flashes until the
loading door gets ready to be opened. The
symbol's light is steady when the door is ready
to open. You can open the door to add/take
out laundry.
Cancelling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be cancelled. "End/
Cancel" light will flash continuously to notify that the
programme has been cancelled.
If you start a new programme after cancelling
C
the previous one, this new programme will start
without draining the water in the machine.
If you must certainly open the loading door
C
when the "Door Open" light is off, you need
All manuals and user guides at all-guides.com
Re-spinning the laundry
Unbalanced load control system can prevent
spinning because of unbalanced load of laundry in
the machine. If you would like to spin again:
Rearrange the laundry in the machine. Select
Spin+Pump programme and press "Start / Pause"
button.
End of programme
"End/Cancel" light on the programme follow-up
indicator will light up once the programme comes
to an end; and "Door Open" symbol flashes for
1-2 minutes until the door is ready to open. When
"Door Open" symbol is steadily illuminated, the
door can be opened.
To turn off the machine, turn program selection
knob to "On / Off" position. Take out your laundry
and close the loading door. The machine will be
ready for the next run.
Door Open
"Door Open" symbol is illuminated when the door is
ready to open. It flashes until the door gets ready to
open. If the "Door Open" symbol is not illuminated,
do not force the door to open. The symbol's light is
steady when the door is ready to open.
5 Maintenance and cleaning
Service life of the product extends and frequently
faced problems decrease if cleaned at regular
intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
(every 4-5 washing cycles) as shown below in order
to prevent accumulation of powder detergent in
time.
Press the dotted point on the siphon in the softener
compartment and pull towards you until the
compartment is removed from the machine.
C
Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning. Insert the drawer back
into its place after cleaning and make sure that it is
seated well.
Cleaning the loading door and the drum
Residues of softener, detergent and dirt may
accumulate in your machine in time and may cause
unpleasant odours and washing complaints. To
avoid this, use the Drum Cleaning programme.
If your machine does not have a Drum Cleaning
9 - EN
to use "Spin+Pump" programme. See
"Spin+Pump"
If more than normal amount of water and
softener mixture starts to gather in the softener
compartment, the siphon must be cleaned.
Publicité
