Sharp Aquos Board 4T-B70CT1U Guide De Configuration page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT INFORMATION
SHARP INTERACTIVE DISPLAY, MODEL 4T-B70CT1U
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RESPONSIBLE PARTY:
SHARP ELECTRONICS CORPORATION
100 Paragon Drive Suite #100
Montvale, NJ 07645 USA
For Business Customers: URL http://siica.sharpusa.com/
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Wireless Radio
For product available in the USA/Canada market, only channel 1–11 can be operated. Selection of other channels
is not possible. This device is going to be operated in 2.412–2.462GHz frequency range.
Important: Any changes or modifi cations not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between
the radiator & your body.
Industry Canada Statement
This Class A digital apparatus complies with CAN ICES-003(A)/NMB-3(A)
Wireless Radio
For product available in the USA/Canada market, only channel 1–11 can be operated. Selection of other channels
is not possible.
The device could automatically discontinue transmission in case of absence of information to transmit, or
operational failure.
Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive
codes where required by the technology.
Important: Any changes or modifi cations not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
IC Radiation Exposure Statement: This device complies with IC RSS-210 rules; Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept interference recieved, including
interference that may cause undesired operation.
Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820
of the National Electrical Code that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as
practical.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful inter ference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful inteference in which case the user will be required to correct the interference at his own expense.
There is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
- 9 -

Publicité

Table des Matières
loading

Table des Matières