Genesis GCQD38A Manuel D'utilisation page 4

• Do not use a ladder or unstable support.
control of the tool in unexpected situations.
• Keep tool handles dry, clean and free from oil and grease.
safely control the tool.
TOOL USE AND CARE
• Secure the workpiece.
Holding the workpiece by hand or against your body is unstable and may lead to loss of control.
• Do not force the power tool.
it is designed. forcing the tool could possibly damage the tool and may result in personal injury.
• Use the correct power tool for the job.
it is not designed.
• Do not use tool if switch does not turn it on or off.
the switch is dangerous and must be repaired or replaced by an authorized service center.
• Turn power tool off, and disconnect the plug
from the power tool before making any adjustments, changing the accessories, or storing the tools. Such
preventive safety measures reduce the risk of an accidental start up which may cause personal injury.
• Store idle tool out of reach of children and other inexperienced persons.
dangerous in the hand of untrained users.
• Maintain power tools with care.
component breaks, and any other conditions that may affect the tool's operation. A guard or any other part that is
damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal injury.
• Use recommended accessories.
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator's manual for recommended accessories
• Keep cutting tools sharp and clean.
are less likely to bind and are easier to control.
• Feed the workpiece in the correct direction and speed.
blade, cutter, or abrasive surface against the direction of the cutting tool's direction of rotation only. Incorrectly
feeding the workpiece in the same direction may cause the workpiece to be thrown out at high speed.
• Never leave the tool running unattended, turn the power off. Do not leave the
tool until it comes to a complete stop.
• Never start the power tool when any rotating component is in contact with
the workpiece.
SERVICE
• Have your power tool serviced by a qualified repair person using only
identical replacement parts.
• Service your power tool periodically.
any portion of the tool since internal wires may be misplaced or pinched.
WARNINg:
instructions before using this equipment. Failure to follow all instructions listed below may
result in electric shock, fire and/or serious personal injury.
4
use clamp or other practical way to hold the workpiece to a stable platform.
The tool will perform the job better and safer at the feed rate for which
Check for proper alignment and binding of moving parts,
This will ensure that the safety of the power tool is maintained.
Read and understand all warnings, cautions and operating
SAVE THESE INSTRUCTIONS
3/8" Close-Quarter Drill
Operator's Manual
Stable footing on a solid surface enables better
Don't force the tool or attachment to do a job for which
from the power source and/or battery pack
using accessories and attachments not recommended by the
.
Properly maintained cutting tools with sharp cutting edges
When cleaning a tool, be careful not to disassemble
GCQD38A
Slippery handles cannot
Any tool that cannot be controlled with
feed the workpiece into a
It is