Kuppersbusch DEF6800.0 Mode D'emploi page 19

Operating settings
1. When the tray is opened, the hood starts
operating at speed 1.
2. To increase speed gradually, press the
maximum speed is set.
3. The sixth speed is timed, so the cooker
hood will automatically revert to the third
speed after seven minutes.
4. To reduce the speed gradually, press the
5. To turn off the cooker hood directly at any
seconds.
Programming stop delay timer
1. Programming Timer
a. Open Tray with motors switched on or off
b.
flicker quickly.
c.
aspiration time. Each LED represents 5
Before carrying
maintenance activities,
extractor is disconnected from the mains.
To carry out cleaning and maintenance, follow
the Safety Instructions.
Fire risk exists in case that cleaning does not
take place according to the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see
notes) or leaving it standing in hot water to
simplify the removal of grease or, if wished, by
means of special sprays (protecting the non
metallic parts). Once clean, leave it to dry.
out any cleaning
ensure that
minutes of operating time. The maximum
operating time is 30 minutes (the LED
corresponding to the intensive speed starts
flickering fast).
d. 5 seconds after pressing the keys, the LED
corresponding to the time stops flickering
fast and the LED corresponding to the
selected speed starts flickering slowly.
e. In stop delay timer Mode, speed can be
2. Cancellation of Stop Delay Timer:
switch off, or close the tray.
Lighting
The lighting can be switched on and off by
When tray is opened, the lighting is switched
on or off, depending on how it was used the
last time.
or
Attention: the cooker hood will not work until
the
the main filter was reinstalled.
Notes: cleaning in the dishwasher with
aggressive
surface of metallic parts, without this affecting
its gas retaining properties.
N.B. The filter must be cleaned at least once a
month depending on how often the extractor
is used. It must be remembered that grease is
deposited in the extractor when cooking,
whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor, paying
pressed until the motors
detergents may blacken
english
the
19