Operating Conditions; Ingress Protection - WIKA O-10 Mode D'emploi

3. Specifications
3.4 Accuracy
Non-linearity
≤ ±0.5 % of span BFSL (per IEC 61298-8)
A different non-linearity applies to some measur-
ing ranges (see 3.1 "Measuring ranges").
Measuring deviation of the zero signal
≤ ±0.5 % of span
A different measuring deviation applies to some
measuring ranges (see 3.1 "Measuring ranges").

3.5 Operating conditions

Ingress protection (per IEC 60529)
The ingress protection depends on the type of electrical connection.
Designation
Angular connector DIN 175301-803 A
Angular connector DIN 175301-803 C
Circular connector M12 x 1.5 (4-pin)
Cable outlet, unshielded
Cable outlet, shielded
1) up to a maximum of 80 °C permitted.
2) not cULus approved.
The stated ingress protection only applies when plugged in using mating connectors that have the appropriate ingress protection.
Vibration resistance
20 g (20 ... 2000 Hz, 120 min.) per IEC 60068-2-6 (vibration under resonance)
WIKA operating instructions pressure transmitter model O-10
IP 65
IP 65
IP 67
1) 2)
IP 67
IP 67
Accuracy at room temperature
≤ ±1.2 % of span
Temperature error (at 0 ... 80 °C)
≤ ±1.5 % of span
Long-term stability
≤ ±0.3 % of span (per year)
Settling time
< 2 ms

Ingress protection

GB
11