Storing Your Iron - Oster DURA PRESS 6020 Manuel D'instructions

CARING FOR YOUR IRON AFTER USE
1. Turn the Steam Lever to O/Off and Fabric Select Dial to Off/Apag.
2. Unplug the Iron from the power source.
WARNING: NEVER yank the power Cord when unplugging the Iron. This can damage
the Cord.
1. Allow the Iron to cool.
2. If you do not use your Iron on a daily basis, empty the Water
Reservoir after each use for a longer Iron life. To do so,
unplug the Iron, turn the Iron upside down, open the Fill Hole
Cover, and allow water to flow from the Fill Hole. Shake the
Iron gently to remove trapped water drops.
3. Loosely loop the power Cord around the heel rest and store
the Iron on its heel rest.
IMPORTANT: Wrapping the Cord around the Iron too tightly can
damage the Cord.
TIP: When not ironing, always set the Steam Lever to O/Off and
the Fabric Select Dial to Off/Apag
.
Turning Off Your Iron

Storing Your Iron

11
f