Storing Your Iron - Oster STEAM MASTER 6014 Manuel D'instructions

CARING FOR YOUR IRON AFTER USE
1. Turn the Steam Lever to
2. Unplug the Iron from the power source.
WARNING: NEVER yank the power Cord when unplugging the Iron. This can damage
the Cord.
1. Allow the Iron to cool.
2. If you do not use your Iron on a daily basis, empty the Water Reservoir after each use
for a longer iron life. To do so, unplug the Iron, turn the Iron upside down, open the
Fill Hole Cover, and allow water to flow from the Fill Hole. Shake the Iron gently to
remove trapped water drops.
3. Loosely loop the power Cord around the heel rest and store the Iron on its heel rest.
IMPORTANT: Wrapping the Cord around the Iron too tightly can damage the Cord.
TIP: When not ironing, always set the Steam Lever to
Dial to O/Off.
CLEANING THE SOLEPLATE
Clean the Soleplate if starch or other residue accumulate.
To clean the Soleplate:
1. Allow the Iron to cool and then wipe it with a soft, damp cloth.
WARNING: DO NOT use abrasive cleansers, scouring pads or vinegar to clean
the Soleplate. This will damage the finish.
2. Run the Iron over an all-cotton cloth to remove any residue.
USING THE SELF-CLEANING FEATURE
You should use the Self-Cleaning feature once a month to maintain the optimal
performance of your Iron.
To use the Self-Cleaning feature:
1. Move the Steam Lever back and forth from
and minerals from the Steam Valve. This keeps water flowing into the steam chamber.
Turning Off Your Iron
and Fabric Select Dial to O/Off.

Storing Your Iron

Maintaining Your Steam Iron
9
and the Fabric Select
several times to remove debris