Filling With Water; Dry Ironing; Steam Ironing - Oster STEAM MASTER 6014 Manuel D'instructions

I N S T RU C T I O NS FOR US E
1. Make sure the iron is unplugged. Set the Steam Lever to
Select Dial to O/OFF.
2. Lift the Water Fill Hole Cover.
3. Fill water cup with water. Pour water into the Iron's Water Reservoir. Do not fill Water
Reservoir beyond maximum fill level.
WARNING: To prevent the risk of burns, be careful when filling a hot iron with water.
Hot metal parts, hot water and steam can cause injuries.
1. Make sure the Steam Lever is turned to the
2. Plug the cord into the outlet.
3. Turn the Fabric Select Dial to the fabric setting you desire (Silk or Synthetics).
Allow the Iron to heat for 2 minutes. While the Iron is heating, make sure it is sitting on
its heel rest on a stable, protected surface.
NOTE: While the Steam Lever is turned to the
SHOT OF STEAM® or SPRAY MIST® features. Please make sure the Water
Reservoir is 1/4 full of water.
TIP: Refer to the "Ironing Guide" for the recommended setting for your fabric.
1. Follow the instructions for "Filling With Water".
2. Plug the cord into the outlet.
3. Turn the Fabric Select Dial to the fabric setting you desire (Synthetic, Silk, Linen,
Cotton or Wool). Allow the Iron to heat for 2 minutes. While the Iron is heating,
make sure it is sitting on its heel rest on a stable, protected surface.
4. Allow the Iron to heat for 2 minutes, and then turn the Steam Lever to the appropriate
setting.
5. Please note that your Steam Iron has an anti-drip system that
prevents water from leaking, spitting, and dripping from the steam
vents, even at the lowest ironing temperatures (model 6015 only).
TIP: Refer to the "Ironing Guide" for the recommended setting for your fabric.
IMPORTANT: When not ironing, always set the Steam Lever to
Fabric Select Dial to O/OFF.

Filling With Water

Dry Ironing

Steam Ironing

4
and the Fabric
setting.
setting, you may still use the
and the