Oster DURA PRESS 6020 Manuel D'instructions page 11

Patented Motion Smart® Auto-Off Feature
When the Iron is plugged in, the Power Indicator will light steadily, indicating that there
is power to the Iron.
If you leave the Iron:
• In a horizontal position without moving it, or accidentally
tip the Iron over, it will automatically stop heating after
30 seconds. The Power Indicator will blink to let you
know that the Iron has stopped heating.
• In a vertical position (on its heel rest) without moving it,
the Iron will automatically turn off after 15 minutes.
The Power Indicator will blink to let you know that the
Iron has stopped heating.
IMPORTANT: The Power Indicator will continue to blink
until the Iron is unplugged or reset.
To reset the Iron:
Move the Iron back and forth and allow it to reheat for
2 minutes. The Indicator Light will stop blinking and
the Iron will start heating again.
WARNING: The patented MOTION SMART® Auto-Off is a safety feature, not a
recommended means for turning your Iron off. See "Caring for Your Iron
After Use" for information on turning off your Iron and storing it safely
between use.
The Anti-Calcium System is a permanent system located inside the Water Reservoir.
This system removes calcium from the water and reduces calcium build-up on
the Soleplate.
(Model 6021 Only)
Anti-Calcium System
10