Oster DURA PRESS 6020 Manuel D'instructions page 13

CLEANING THE SOLEPLATE
Clean the Soleplate if starch or other residue accumulate.
To clean the Soleplate:
1. Allow the Iron to cool and then wipe it with a soft, damp cloth.
WARNING: DO NOT use abrasive cleansers, scouring pads or vinegar to clean the
Soleplate. This will damage the finish.
2. Run the Iron over an all-cotton cloth to remove any residue.
USING THE SELF-CLEANING FEATURE
You should use the Self-Cleaning feature to maintain the optimal performance of your
iron. The Self Cleaning feature will clean the Water Reservoir and steam vents of
accumulated minerals, dust and lint.
To use the Self-Cleaning feature:
1. Move the Steam Lever from O/Off to
times to remove debris and minerals from the steam valve.
CLEANING THE ANTI-CALCIUM SYSTEM
Your Steam Iron houses an Anti-Calcium Filter in the Reservoir, which eliminates
impurities from the water.
To prolong the efficiency of this filter:
1. Unplug the Iron and allow it to cool.
2. Locate the water cup that accompanied the Iron. Fill it
with water to the Max Fill mark. Add 1 teaspoon of salt
to the water and fill the Water Reservoir with this solution.
3. Leave the solution in the Water Reservoir for 15 minutes,
then empty it.
4. Fill the Water Reservoir a second time with the salt water solution and empty it again
after 15 minutes.
5. Fill the Reservoir with fresh water to rinse and empty.
The Anti-Calcium System should be cleaned approximately once a month.
Maintaining Your Steam Iron
several
12