Publicité
Les langues disponibles
Les langues disponibles
4.
a. Spread the bottom of the bracket cover
approximately 1". There are two different clips
on the bottom side of the bracket, a solid band
(left side) and a 3 nger band (right side). Wrap
the cover around the rail as close to the post as
possible (Fig. 14).
b. Hook the solid band (left side) of the clip into
the underside of the bracket rst. Squeeze the
cover together from the sides until the 3 nger
band snaps into the underside of the bracket
(Fig. 15).
c. To remove, disengage the solid band (left side)
rst then reverse installation steps to complete
removal.
NOTE:
A at head screw driver may be needed to
disengage the 3 nger clip to begin the removal
process.
5.
Assemble the 2 piece post trim cover by inserting
one fastener in each trim half (Fig. 16). Snap
these in place (Fig. 17) concealing the post
ange.
Fig. 14
Fig. 15
Fig. 16
Fig. 17
5
Publicité
