Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If the tool stops under no or light load, recharge or
replace the battery cartridge.
Hook
007300
The tool may be hung using the hook. Hang tool on a
pipe vice or other suitable, stable structure.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the blade
CAUTION:
Oil on the blade can cause the blade to slip or
•
come off unexpectedly. Wipe off all excess oil with
a cloth before installing the blade.
Use caution when handling the blade so that you
•
are not cut by the sharp edge of the blade teeth.
Turn the blade tightening lever clockwise until it hits
against the protrusion on the frame.
4
1
2
3
007150
Match the direction of the arrow on the blade to that of
the arrow on the wheels.
1
3
006192
1. Hook
1
1. Tighten
2. Loosen
3. Protrusion
4. Lever
1. Blade
2. Bearing
4
3. Upper holder
4. Lower holder
2
Insert the blade between the bearings of the upper
holder first and then into the lower holder. The blade
back should contact the bearings in the lower portion of
the upper holder and lower holder.
Position the blade around the wheels and insert the
other side of the blade within the upper holder and lower
holder until the blade back contacts the bottom of the
upper holder and lower holder.
2
1
3
006193
3
1. Blade guide
2. Groove
3. Blade
015673
Put the blade into the groove in the blade guide.
Hold the blade in place and turn the blade-tightening
lever counterclockwise until it hits against the protrusion
on the frame. This places proper tension on the blade.
Make sure that the blade is correctly positioned within
the blade guard and around the wheels.
Start and stop the tool two or three times to make sure
that the blade runs properly on the wheels.
CAUTION:
While making sure that the blade runs on the
•
wheels properly, keep your body away from the
blade area.
To remove the blade, follow the installation procedure in
reverse.
7
1. Upper holder
2. Lower holder
3. Wheel
4. Press
4
1
2
Publicité
Table des Matières
