Speed Adjusting Dial - Makita DPB180 Manuel D'instruction

Indicator lamps
Lighted Off
015658
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
A
007147
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF" position
when released.
To prevent the switch trigger from accidentally pulled,
the lock-off button is provided.
To start the tool, depress the lock-off button from B side
and pull the switch trigger.
Release the switch trigger to stop. After use, always
press in the lock-off button from A side.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1. Lock-off button
1
2. Switch trigger
B
2

Speed adjusting dial

1
007148
The tool speed can be infinitely adjusted between 1.4
m/s (275 ft/min) and 2.7 m/s (530 ft/min) by turning the
adjusting dial. Higher speed is obtained when the dial is
turned in the direction of number 6; lower speed is
obtained when it is turned in the direction of number 1.
Select the proper speed for the workpiece to be cut.
CAUTION:
The speed adjusting dial can be turned only as far
•
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
Lighting up the lamp
007149
CAUTION:
Do not apply impact to the lamp, which may cause
•
damage or shorted service time to it.
Pull the switch trigger to light up the lamp. The lamp keeps
on lighting while the switch trigger is being pulled. The
lamp goes out 10 -15 seconds after releasing the trigger.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Do not use thinner or gasoline to clean the lamp.
•
Such solvents may damage it.
Battery protection system
The tool is equipped with the protection system, which
automatically cuts off the output power for a long service
life of the battery cartridge.
When the tool is overloaded or the remaining battery
capacity gets low, the lamp flickers. Within one second
after flickering, the tool stops.
6
1. Speed adjusting
dial
1. Lamp
1