Tips For Best Results - DeWalt DXGST227CS Manuel De L'utilisateur

WARNING:
length will make the unit overheat. This may lead to serious personal injury or damage to
the unit.

TIPS FOR BEST RESULTS

• For most operations, cut from side to side.
• DXGST227CS: To direct clippings away from the operator, tilt the cutting head slightly down to the
left; cut from right to left whenever possible.
• DXGST227SS: To direct clippings away from the operator, tilt the cutting head slightly down to the
right; cut from left to right whenever possible.
• Cut tall grass (over 8 inches (20cm)) from the top down by lowering the cutting head onto the grass.
• Cut with the tip of the trimming line.
• Cut in small increments. Move slowly. Do not force the unit.
• Do not trim wet grass or weeds.
NOTE: Some line breakage will occur from:
• Entanglement with foreign matter
• Normal line fatigue
• Attempting to cut thick vegetation
• Forcing the line into objects such as walls or fence posts
DECORATIVE TRIMMING
When trimming around trees, posts, fences, etc., rotate the whole unit so that the cutting head is at a
30° angle to the ground (Fig. 19).
Do not remove or alter the line cutting blade assembly. Excessive line
Bump Knob
Fig. 18
26