Hiyasu ASE 18UB Manuel D'instructions page 69

06Manual 2Hiyasu Eng 7/4/06
COOL,HEAT and DRY operation
(1) Unit start
Press ON/OFF button, unit starts.
Previous operation status appears on display.(Not Timer setting)
Power indicator on indoor unit lights up.
(2) Select operation mode
Press MODE button. For each press, operation mode changes as follows:
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
(3) Select temp. setting
Press TEMR button.
Every time the button is pressed, temp. setting increases 1oC
Every time the button is pressed, temp. setting decreases 1oC
Unit will start running to reach the temp. setting on LCD.
(4) Fan speed selection
Press FAN button. For each press, fan speed changes
as follows:
Unit runs at the speed displayed on LCD.
In HEAT mode,warm air will blow out after a short period of time due to cold-draft
prevention function.
In DRY mode, when room temp. becomes 2ºC lower than temp. setting, unit will
run intermittently at LO speed regardless of FAN setting.
COOL operation starts when room temp. is hig-
her than temp. setting.
Temp. setting+2ºC
Temp. setting
Hints
just press ON/OFF button and unit will run in previous status.
On cooling only unit, heating mode is not available.
Remote controller can memorize each operation status. When starting it next
time, just press ON/OFF button and unit will run in previous status.
67
All manuals and user guides at all-guides.com
09:22 Página 67
OPERATION
Ultra-low air flow
On reaching temp. setting, unit will run in mild
DRY mode.
67