Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Ensure that the drill bit is not in contact
with the workpiece prior to starting up the
tool.
•
Before drilling, check that there is suffi-
cient clearance for the drill bit under the
workpiece.
•
Drill bits get hot during operation, allow to
cool prior to handling them.
•
NEVER use your hands to remove saw-
dust, chips or waste close by the bit.
•
Examine the chuck regularly for signs of
wear or damage. Have damaged parts
repaired by a qualified service centre.
•
ALWAYS wait until the drill has come to a
complete stop before putting it down.
BEFORE USE
•
Avoid damage that can be caused by
screws, nails and other elements in your
workpiece; remove them before you start
working
•
Use suitable detectors to find hidden utility
lines or call the local utility company for
assistance (contact with electric lines can
lead to fire or electrical shock; damaging a
gas line can result in an explosion; pene-
trating a water pipe will cause property
damage or an electrical shock)
•
Secure the workpiece (a workpiece
clamped with clamping devices or in a
vice is held more securely than by hand)
DURING USE
•
Hold power tool by insulated gripping
surfaces (8), when performing an opera-
tion where the cutting accessory or fas-
tener may contact hidden wiring (cutting
accessory and fasteners contacting a
"live" wire may make exposed metal parts
of the power tool "live" and could give the
operator an electric shock)
•
In case of electrical or mechanical mal-
function, immediately switch off the tool or
unplug charger from power source
BEFORE FIRST USE
remove the machine and the accessories from
the packaging. Check the machine for trans-
port damage and do not use the machine in
7062504-Cordless_Combi_Drill-Ma-1702-06.indb 9
case of damages. Keep the packing materials
away from children, risk of suffocation!
INTENDED USE
the cordless hammer drill/screwdriver is
designed for tightening and undoing screws,
for drilling in wood, metal and plastic, and for
hammer drilling in stone, in each case when
using the appropriate bits. The equipment is to
be used only for its prescribed purpose.
OPERATION
Direction control
•
The direction of rotation can be set using
the Forward/Reverse Switch (7)
•
For anti-clockwise rotation, push the
switch to the right
•
For clockwise rotation, push the switch to
the left
Note: When the Forward/Reverse Switch is in
the central position, the drill is locked and
cannot be switched on. Use this setting as a
safety feature to prevent the drill from being
switched on accidentally.
Mode selector
The clutch settings are indicated by the sym-
bols on the Mode Selector (4)
Torque Selector
Rotate the Torque Selector (3) to select the
desired setting: the higher the number dis-
played on the torque ring, the higher the torque
produced by the tool
Speed setting
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (5) forward
or backwards. The number on the gear switch
(5) shows which position is chosen.
Position 1: For slow drilling, large drilling
diameter or screw driving. The machine has
higher torque at a low speed.
Position 2: For fast drilling or small drilling
diameter. The machine has lower torque at a
high speed.
.
English
9
27-09-17 09:18
Publicité
Table des Matières
