HP Designjet 3D Informations D'introduction page 3

FDM Process
®
1. From 3D CAD data, pre-processing software automatically slices, calculates support structures and cre-
ates tool paths that are optimized for the printer.
2. Parts are built layer by layer in an additive process. Dual extrusion heads precisely lay down thermo-
plastic model and support material to create each layer.
3. Temporary support structures are easily removed. Soluble support material automatically dissolves in a
water-based solution.
Printer Overview
1
2
3
1 Display panel
2 Material bay, support side
3 Optional material bay, support side
4 Optional material bay, model side
5 Material bay, model side
6 Power Switch
Front and left side views
6
5
4
3