Selve commeo Notice De Réglage page 32

EN Setting the parameters wind and inclination
Step 3
• Demount the housing cover.
• Set the requested sensitivity of the inclination angle detection at the
step switch.
Value Description
0 Inclination angle detection OFF
1 Reaction when the inclination angle changes by more than ± 1°
2 ... 8 Reaction when the inclination angle changes by more than ± 2° ... 8°
9 Reaction when the inclination angle changes by more than ± 9°
Step 4
Caution!
• Put the housing cover onto the base plate and screw them together.
• Switch on the power.
Warning!
Step 5
Caution!
• Automatic calibration of the inclination angle: The drop file must be
motionless (=windstill) for at least 30 seconds!
Warning!
• Test the function „retraction" by slow vertical moving of the drop file.
• Observe the awning characteristics. Do not destroy the awning!
• Awning retracts already at low inclination: Back to step 2
Set higher values at the step switch.
• Awning does not retract even at high inclination: Back to step 2
Set smaller values at the step switch.
Note:
After exceeding the set inclination angle and retracting of the awning,
the awning can be extended immediately. There is no blocking period.
Warning!
32