Liquid Propane (Lp) Safety Information - Landmann 42125 Instructions De Montage, D'entretien Et D'utilisation

Liquid Propane (LP) Safety Information

Please review the below guidelines and safety information when using Liquid Propane (LP) gas.
General Information
• This grill is designed to be used with a standard 20
lb. LP gas cylinder.
• Any brand of 20 lb. LP gas cylinder is acceptable
for use on this grill, provided that it is compatible
with the grill's retention means (tank tray bolt).
• This grill is designed certified by CSA international
for local LP gas supply.
• This grill CANNOT be converted to natural gas.
DO NOT attempt to convert this grill with a
different gas type.
Safety Information
• LP gas has an odor similar to natural gas.
• LP gas is heavier than air and leaking gas may
collect in low areas and resist dispersion.
• LP cylinders must be installed, transported and
stored in an upright position.
• LP cylinders should not be dropped or handled
roughly.
• DO NOT use a damaged LP cylinder. A dented or
rusty LP cylinder or an LP cylinder with a damaged
valve may be hazardous and should be replaced
with a new cylinder immediately.
• ALwAyS close the cylinder valve after use.
• ALwAyS close the cylinder valve when
disconnecting the regulator.
• ALwAyS treat possible empty LP cylinders with
the same care as a full LP cylinder. There may
still be gas pressure inside a possible empty LP
cylinder.
• NEvEr store or transport an LP cylinder where the
temperature can reach 125ºF.
• Keep LP cylinders away from children and pets.
• DO NOT store disconnected LP cylinders in a
building, garage or other enclosed areas.
• If the LP cylinder is kept in the grill between uses,
make sure to keep both the grill and the cylinder in
an outdoor area with good ventilation.
• ALwAyS leak test the LP cylinder connection to
the regulator whenever changing LP cylinders.
Installation of LP Cylinder
1. Maker sure all burner controls are in the • OFF
position.
2. Open the cabinet door.
3. Carefully position in the large hole on the bottom
panel.
4. To secure the LP cylinder in place, screw the tank
holding tray bolt through the bottom section of the
LP cylinder.
5. Attach the regulator to the cylinder by carefully
HAND TIGHTENING only.
6. NEvEr use a wrench or other tool to tighten this
connection.
7. Observe all governing codes and ordinances.
Important
The United States LP gas appliance installation must
conform with local codes and ordinances. In the
absence of local codes, appliance installation must
conform with either the National Fuel Gas Code, ANSI
Z223.1/NFPA54, Natural Gas and Propane Appliance
code, CSA B149.1, or Propane Storage and Handling
Code, B149.2, as applicable.
For Canada, installation of this grill must comply with
local codes and/or Standard CSA-B149.2 (Propane
Storage and Handling Code).
5