Bosch 1619EVS Consignes De Fonctionnement/Sécurité page 18

BM 2610933969 9-05
For safe operation, read and understand this router manual and the router
!
WARNING
table's manual before using either.
ATTACHING ROUTER TO MOUNTING PLATE
1. Remove the router sub-base.
2. The router is now ready for mounting to a
router table. Install router to mounting plate
and router table according to the instructions
provided with that accessory.
3. Attach the base to your router table using four
1/4"-20 x 1-1/2" Phillips machine screws,
washers and nuts. The length will depend on
the thickness of your router table or router
table mounting plate.
ADJUSTING THE DEPTH
1. Install the desired bit.
2. Lift router motor to approximate desired height
and lock coarse adjust lock.
3. When used in the router table, most depth-of-
cut adjustments will be made with the fine
adjustment knob. For easier under-table height
adjustment, press the optional fine adjustment
knob extension onto the end of the fine
adjustment knob. (Fig. 25)
FIG. 25
CONNECT THE ROUTER AND THE ROUTER
TABLE SWITCH
To prepare for use of the switch,
1. Make sure the router switch and the router
table switch are both turned off.
2. Plug the router table switch cord to wall outlet.
3. Plug the router into the "pigtail" socket on the
router table switch.
4. Lock router switch on: squeeze trigger,
depress lock-on button, and release trigger.
5. Use the router table switch to start and stop
the router.
9/2/05 8:41 AM Page 18
Operation in Router Table
FEEDING THE WORKPIECE ON
A ROUTER TABLE
Always use your router table's fence or starter
pin and the appropriate guard and follow the
router table's instruction manual. ALWAYS feed
the workpiece from right to left across the front
of the bit. On Bosch router tables, the correct
feed direction is also shown on fence housing
and on the featherboards, when they have been
properly installed. (Fig. 26)
Whenever possible, when using the fence, use
a push stick to push the workpiece, especially
when working with narrow pieces.
FENCE FACE
BIT
BEARING
TOP VIEW
NOTE: For clarity, guard and featherboard
removed from drawing.
RESTORING THE ROUTER TO NORMAL
UPRIGHT (HAND-HELD) PLUNGE
OPERATION
1. Remove the router from the table and bring it
back to its normal upright position.
2. Remove the bit and collet chuck.
3. Remove the router table mounting plate and
reattach the router's sub-base.
4. While supporting the router with one hand,
release the coarse adjust lock by turning it to
the left. Then lower the motor until it comes to
a rest.
5. Reactivate the plunge return spring by
pressing the router motor further down. The
router will automatically pop up from its own
spring pressure.
6. Release the depth rod from to keyhole in the
depth stop turret. (The rod needs to be moved
downward slightly in order to clear the small
circular recess on the underside of the smaller
end of the keyhole.)
-18-
FIG. 26
DIRECTION
OF FEED
FENCE FACE
WORKPIECE