Inglesina DARWIN NEXT STAGE i-SIZE Manuel D'instructions page 31

INSTALLATION OF THE CHILD SEAT ON THE DARWIN i-SIZE CAR BASE
• Install the Darwin i-Size Base on board of the car referring to the dedicated manual.
• Caution: before installing the Darwin Next Stage i-Size child seat, ensure that the
base is clear of any object.
• Warning! Do not install with storage compartment under the car mat.
"REARWARD FACING" POSITION (40 - 105 CM)
fig. 4
Install the Darwin Next Stage i-Size car seat by fitting the two outer silver
tubes located on the bottom of the child seat (E), in the fastening housings (L) on the
base, until they click correctly.
fig. 5 The Darwin Next Stage i-Size car seat is attached when the dedicated
indicators (L1) change from red to green.
fig. 6
Always make sure the child seat is fastened correctly before using it. Try to
pull it away, even vigorously.
• Important - Never use the child seat in forward facing position before the child
is over 15 months of age.
• The rearward facing position ensures top safety of the child inside the car.
According to the instructions of ECE R129 regulations, it is recommended to use
the rearward facing position for the child seat even after 15 months of age.
• Install the Darwin i-Size Base on board of the car referring to the dedicated manual.
• Caution: before installing the Darwin Next Stage i-Size child seat, ensure that the
base is clear of any object.
• Warning! Do not install with storage compartment under the car mat.
fig. 7
Install the Darwin Next Stage i-Size car seat by fitting the two outer silver
tubes located on the bottom of the child seat (E), in the fastening housings (L) on the
base, until they click correctly.
fig. 8
The Darwin Next Stage i-Size car seat is attached when the dedicated
indicators (L1) change from red to green.
fig. 9
Always make sure the child seat is fastened correctly before using it. Try to
pull it away, even vigorously.
REMOVING THE CAR SEAT FROM THE DARWIN i-SIZE BASE
fig. 10
Operate the release lever (M) on the base until hearing the release click: the
suitable indicators on the base (L1) turn from green to red.
fig. 11 Keep the release lever (M) pressed, lift and remove the child seat.
INSTALLATION OF THE CHILD SEAT ON THE DARWIN 360° i-SIZE CAR BASE
• Install the Darwin 360° i-Size Base on board of the car referring to the dedicated manual.
• The Darwin 360° i-Size base can rotate to facilitate positioning of the child and
installation of the car seat in the car.
fig. 12
Using the front levers (N) rotate the car seat installation seat (P) to the
desired position.
"FORWARD FACING" POSITION
(AGE OVER 15 MONTHS / 76-105 CM)
(IN BOTH CONFIGURATIONS)
31