User Keypad Operation; Fill Your Whirlpool - Kohler K-1394 Manuel D'instructions

Rotate outer ring to
access desired mode.
Power On/Off
Chromatherapy-Specific Color
(H2 models only)

User Keypad Operation

NOTE: Symbols illuminated in blue indicate available modes/features. Active modes will be illuminated
in green.
Chromatherapy Cycle (H2 Models Only) - Chromatherapy lights will automatically and
continuously cycle through the eight colors: white, violet, indigo blue, aqua blue, green, yellow,
orange, and red. One cycle through all eight colors takes approximately one minute.
Chromatherapy Specific Color Selection (H2 Models Only) - When this mode is selected, you may
choose a specific color for the bath.
Waterfall Mode - You may use the Waterfall alone, or with any one of the following: Flexjets, or
Riverjets in either the Whitewater mode or Rapids mode.
Whitewater - The Whitewater mode activates the two outside Riverjets behind your neck to provide
a swirling action.
Rapids - The Rapids mode activates all four Riverjets behind your neck to provide a swirling action.
Tidepool - This feature turns off the air flow to the jets for a soothing, relaxing effect. The Tidepool
feature may be used at any time while any of the jets are operating. The Tidepool mode does not
affect the Waterfall.
Flexjet Mode - The eight Flexjets, located lower in your whirlpool than the Riverjets, provide an
invigorating whirlpool action.

Fill Your Whirlpool

NOTE: Please read these steps carefully before operating your whirlpool.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
NOTE: For Waterfall only use (no Flexjets or Riverjets), you only need to fill the bath to a level about 2"
(5.1 cm) above the top of the suction covers.
NOTE: For Waterfall or Flexjet use (no Riverjets), you only need to fill the bath to a level about 2" (5.1 cm)
above the top of the highest Flexjet.
To operate all the features: Fill the whirlpool to a level above the water-level sensors on either side
of the Riverjets.
Kohler Co.
All manuals and user guides at all-guides.com
Flexjet Flow Mode
Activates Mode
Selected
Waterfall
Mode
Lighted User Keypad
Riverjet Whitewater Mode
Increases Flow
Riverjet Rapids Mode
Indicator Bar - Shows
water flow volume
Tidepool
Decreases Flow
Chromatherapy Cycle
(H2 models only)
Heater
5 1022209-5-D