Velleman PROMIX8000 Mode D'emploi page 3

B. LINE / PHONO SECTION
1. INPUT SELECTORS:
These selectors are used to select the input
signal: LINE or PHONO.
2. GAIN CONTROL:
These rotary controls are used to adjust the
level of the input signal. Useful to harmonise
the level of all the inputs.
3. TONE CONTROLS (HIGH, MID, LOW):
These three rotary levels (per channel) are
used to adjust the frequency response.
They correct the signal's high, mid and low
frequencies in a range from +12 to -26dB.
4. AUX1 SEND FADER:
This auxiliary send control can be used to
control the mix of inputs being processed by
effects etc.
5. AUX2 SEND FADER:
This auxiliary send control can be used to
control the mix of inputs being processed by
effects etc.
6. CUE SWITCH:
This switch allows pre-fade listen of input
signals through headphones and LED
meters. This is especially useful while
setting gains.
7. ROTARY BALANCE CONTROL:
This control is used to adjust the input
signal to either left or right.
8. PEAK LED:
The PEAK LED warns for channel overload,
which could cause audible distortion.
Reduce channel output volume to mixer's
input until the PEAK LED lights only
occasionally during the loudest moments in
the material playing.
9. SLIDE VOLUME CONTROL:
This control varies the overall level of an
individual channel in the main output mix.
10. CROSSFADER:
This linear slide is used for the mix between
the CH1-4 channels. The crossfader is
removable to make an easy and fast
replacement.
11. ASSIGN SWITCHES:
These switches allow assigning channels
from CH1-4 to either side of the crossfader.
PROMIX8000
All manuals and user guides at all-guides.com
3
VELLEMAN