Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALL BASE GRILLE
There are two pieces to the base grille to allow for a
custom fit: the base grille itself and the skirt. The skirt can
be added to the base grille in order to extend it all the
way to the floor.
1.
To see whether the skirt is needed, place the base
grille into position. Do not attach the base grille to
the refrigerator. Measure the distance between the
bottom of the base grille and the floor. The gap must
be a minimum of 1/2" (1.27 cm) in order to add the
skirt.
NOTE: If the gap measures less than 1/2" (1.27 cm),
skip steps 3 and 4 of the instructions, and install the
base grille only.
2.
Remove the film from the base grille.
3.
Snap the skirt onto the base grille.
A. Base grille
B. Skirts
4.
Trim the skirt by scoring the proper "V" groove with a
utility knife. Break the skirt at the score line.
A. "V" groove
5.
Using the two screws, attach the base grille assembly
to the refrigerator as shown.
NOTE: Drive in the right side screw first.
A
A. Screws (2)
A
B
A
COMPLETE INSTALLATION
1.
Turn the water supply line valve to the "Open"
position.
2.
Turn the refrigerator switch to the ON position. See
"Power On/Off Switch" in the Use & Care Guide for
instructions. Wait a few minutes. Check the water line
connections for leaks.
3.
Remove all boxes, parts packages and packing
materials from the interior of the refrigerator. See
the "Cleaning" section in the Use & Care Guide for
instructions. Remove the film and cardboard from
the grille and doors or door frame, depending on
your model.
4.
Install the shelves and bins in the refrigerator and
freezer compartments.
5.
The controls are preset at the factory to the midpoint
setting. Make sure the compressor is operating
properly and that all the lights are working.
6.
Flush the water system before use. See "Water
System Preparation."
To get the most efficient use from your new built-in
refrigerator, read the Use & Care Guide. Keep Installation
Instructions and Use & Care Guide near the built-in
refrigerator for easy reference.
WATER SYSTEM PREPARATION
Please read before using the water system.
IMPORTANT: After connecting the refrigerator to a water
source or replacing the water filter, follow the steps below
to make sure that the water system is properly cleaned.
This will flush air from the filter and water dispensing
system, and prepare the water filter for use.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
NOTE: If your model has a base grille filter system, make
sure the base grille filter is properly installed and the cap
is in the horizontal position.
30
Publicité
Table des Matières
