Jennair JBBFX24NHX Guide

ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A 115 V, 60 Hz, AC only, 15 A or 20 A fused, grounded electrical
supply is required. It is recommended that a separate circuit
serving only your refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the control (Thermostat, Refrigerator
or Freezer Control depending on the model) to OFF and then
disconnect the refrigerator from the electrical source. When you
are finished, reconnect the refrigerator to the electrical source
and reset the control (Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired setting. See "Using the
Controls."
LOCATION REQUIREMENTS
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
Floor must support the refrigerator weight, more than 600 lbs
(272 kg), door panels, and contents of the refrigerator.
Each refrigerator needs to be installed in a separate cabinet
frame.
NOTE: This refrigerator is intended for use in a location where
the temperature ranges from a minimum of 13°C (55°F) to a
maximum of 43°C (110°F). The preferred room temperature range
for optimum performance, which reduces electricity usage and
provides superior cooling, is between 15°C (60°F) and 32°C
(90°F). It is recommended that you do not install the refrigerator
near a heat source, such as an oven or radiator.
Because Whirlpool Corporation policy includes a continuous commitment
to improve our products, we reserve the right to change materials and
specifications without notice.
W11602961A
Bottom Mount Refrigerator
OPENING DIMENSIONS
This refrigerator is designed to be installed inside a frame that ts
between kitchen cabinets. The inside of the frame should be a
minimum of 69 / " (1776 mm) high, 22
15
16
21 / " (555 mm) deep (front to back).
7
8
For proper ventilation, you must allow adequate unobstructed
space behind the refrigerator and below and above the frame. Air
enters below the refrigerator and exits above it.
Allow a clearance minimum of 2" (50 mm) at the top of the frame.
The minimum depth of the base of the frame is 20
(front to back).
The base can be as desired, but height should match height of
toe kick of surrounding cabinets. A vent with an opening of at
least 31 sq in. (200 sq. cm) is required for proper ventilation.
If the space between the top of the frame and the ceiling is open
air, allow a minimum of 7
If the space between the top of the frame and the ceiling is
enclosed as part of the surrounding cabinetry, a vent with an
opening of at least 31 sq. in. (200 sq. cm) is required.
The bottom of the vent must be a minimum of 7
above the refrigerator.
NOTE: Vent covers are not supplied with the unit.
E
A
Dimension Table
A 69 /
15
16
B 22 /
1
16
C Minimum 21
D Minimum 20
E Minimum 2" (50 mm)
F 69 /
11
16
G 21 /
15
16
H 21 /
7
16
I 2 /
15
16
J 1 / " (28 mm)
3
32
K 40 /
11
32
Dimensions are for planning purposes only. For complete details, see
Owner's Manual packed with product. Specifications subject to change
without notice.
1
/ " (560 mm) wide, and
1
16
/ " (200 mm) above the refrigerator.
7
8
/
7
8
3/16"
(4 mm)
B
H
G
K
C
L
D
I
F
N M
O
" (1776 mm)
" (560 mm)
/ " (555 mm)
7
8
/ " (520 mm)
7
16
" (1770 mm)
" (557 mm)
" (545 mm)
" (75 mm)
" (1024.5 mm)
/ " (520 mm)
7
16
" (200 mm)
1/4"
(6 mm)
1 /
1
"
8
(28 mm)
J