Stainless Series Custom Side Panels - Jennair JBSFS42NMX Mode D'emploi

STAINLESS SERIES CUSTOM SIDE PANELS

Custom side panels may be needed when not enough
space is available to have cabinets on both sides of the
refrigerator or when the refrigerator is placed at the
end of a cabinet run. You may choose an Inset, Flush, or
Recessed Inset panel installation.
BACKER
The width and height of a side panel are determined by
the type of installation you are planning.
NOTE:
The dimensions shown are actual product dimensions
and may not reflect the needed panel installation
dimensions.
The side panel should be a minimum of 1/2" (1.27 cm)
thick to avoid warping.
If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on rear wall.
Refrigerator
2319/ "
32
(59.9 cm)
2317/ "
32
(59.8 cm)
2315/ "
32
(59.6 cm)
Side Trim
11/16" (18 mm)
1/2" (12.2 mm)
9/16" (13.9 mm)
5/8" (15.7 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the
back wall. Add 1/16" (1.6 mm) to this measurement to
allow the side panel to fit into the trim.
2. If the panel is more than 5/16" (8.7 mm) thick, route
the front edge to allow the side panel to fit into the
trim.
A
Inset Installation Dim
1. Measure the distance from point A (as shown) to back
wall.
2. Route the front edge of the support board or attach
a 3/8" (9.5 mm) board to hold the panel in the cabinet
side trim.
A
18