Install Refrigerator And Panels - Jennair JBSFS42NMX Mode D'emploi

After moving the refrigerator to its final location:
1. Use a 5/16" socket driver to turn the leveling bolts
clockwise to extend the legs to the floor as shown.
The rollers should be off the floor.
A
B
A. Rear leveling bolt
B. Front leveling bolt
2. Adjust the leveling legs to level and align the
refrigerator from left to right and front to back so
that the refrigerator is level and aligned with the
cabinetry. The cabinetry surface must be plumb for
the ideal fit of the refrigerator side trim.
3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm)
of the top soffit.
NOTE: If an anti-tip board has been used, adjust the
leveling legs until the top of the refrigerator is within
1/4" (6.35 mm) of the bottom of the anti-tip board as
shown. Do not crush the compressor cover.
2" (5 cm)
D
A. Center board 1/4" (6.35 mm) maximum above refrigerator
B. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with
the door alignment or top grille fit. To avoid damage to
the cabinet or leveling legs, do not apply more than
50 inch-pounds (5.65 Nm) of torque to the leveling bolts.
The leveling legs can be extended to a maximum of
1¹⁄ " (3.18 cm) below the rollers.
4
25
A B
C
1/4"(6 mm)
maximum

INSTALL REFRIGERATOR AND PANELS

IMPORTANT: JennAir is not responsible for the removal
or addition of molding or wood overlay panels that would
not allow access to the refrigerator for service.
INSTALL TOP GRILLE FILLER (STANDARD
INSTALLATION ONLY)
IMPORTANT: The grille panel height allows the necessary
airflow for refrigerator performance. The top grille filler
hides the upper compartment cover behind the top grille.
If you choose to modify the recommended grille panel
A
dimensions, performance will be compromised.
B
1.
In the custom made (1" x width of grille panel) wood
filler piece, drill a hole 11/16" from each edge.
NOTE: Make sure the hole is centered in the 1"
thickness of the wood piece.
2. Using slotted hex-head screws (provided with
refrigerator), fasten an "L" bracket to each end of the
wood filler piece.
3. Using hex-head blunt screws (provided with
refrigerator), attach the "L" brackets to the top grille
mounting plates.
4. Adjust the "L" brackets, so that the wood filler piece is
flush with the bottom of the soffit. Completely
tighten the screws.
A
B
C
Side View
A. Top grille filler
B. Soffit
C. Airflow
A. Top grille filler
B. "L" bracket
C. Grille mounting plate
A
B
C
D
E
D. Grille panel
E. Door panel