Your Domus / Luna Petite Wood-Burning Stove At A Single Glance; Installation; Lighting The Stove - WANDERS Domus Mode D'emploi Et Instructions D'installation

Your Domus / Luna Petite wood-burn-
ing stove at a single glance
The Domus / Luna Petite
The Domus / Luna Petite is a combination of comfort
and efficient heat output. The stove has an outside cover
and an interior chamber. This ensures that the stove
radiates 70% of the heat output through convection to
your room while the remaining 30% heat is released
through radiation via the glass area. The automatic
thermostat valve regulates the air supply to your wood-
burner when all other openings are closed. Open the
valve completely when lighting the stove. Once the
stove has heated up, the valve will close automatically
to minimize the chance of overheating while you can
enjoy the sight of a generous fire.
In addition to the thermostat valve, the Domus / Luna
Petite has a preheated glass pane cleaning system and
an ingenious extra air circulation system which uses flue
gases for afterburning. High-quality cast iron and the
vermiculite internal lining ensure optimum heat yield.

Installation

It is common practice for the dealer where you purchased
your stove to also take care of installing it. If this is not
the case, please ensure that the installation is done by a
certified installer. A certified installer can also give you
the right advice about the flue tube to which the stove
must be connected. Connecting wood-burning stoves
16
by unqualified persons is prohibited, in which case we
cannot give any guarantee about proper functioning
of your stove. Please bear the fire safety in mind when
installing the stove. See also page 21.
The wood-burning stove is suitable as an extra heat
source and does not replace your principal heating
device.
It is not allowed to have wood-burning stoves connected
by unqualified installers. In such case we cannot give
any guarantee that the Domus / Luna Petite will work
properly.
Lighting your stove early in autumn or late in
winter
When the external and internal temperatures do
not differ much, a proper chimney draught is a real
challenge. You can help chimney draught get started
by burning some wood while keeping all air inlets
maximally open. An abundant air supply speeds up
quick heating which in turn increases the draught
in the chimney. Lighting up the stove with only a
little wood prevents smoke from streaming into the
room.

Lighting the stove

The stove can get very hot when lighted and needs at
least two hours to cool off. Don't touch the stove without
protection during firing and for two hours after. Always
use gloves when handling the stove to avoid getting
serious burns.
The automatic thermostatic valve
Open the door and put some balls of paper or firelighters
in the stove and place some wood kindling on top. Fully
open the automatic thermostat valve (see photograph).
Open the grate shaker with the shaking bar and keep the
ash pan open for the first five to ten minutes to let extra
air in. Light the kindling and leave the door ajar for extra
air supply. Once the stove is burning you can